_md e ss_s <c_Hs_s_ss_Remeved

PARTS INCLUDED: Door handles (2), 1/8" hex key, spare setscrews

To Install the Handles:

NOTE: The handle mounting setscrews are preinstalled in the handle.

Remove the handles, which are packed inside the refrigerator.

NOTE: To avoid scratching the finish, place the handles on a towel or other soft surface.

2.Open the freezer door. On the refrigerator door, place the handle on the shoulder screws with the setscrews facing the freezer.

IMPORTANT: When the screws feel tight, tighten them an additional quarter-turn. The handle is not properly installed without this extra tightening.

Open the refrigerator door and close the freezer door. Repeat steps 2 through 7 to install the other handle onto the freezer door with the setscrews facing the refrigerator.

Save the hex key and all instructions.

To Remove the Handles:

1.While holding the handle, insert the short end of the hex key into the lower setscrew hole and slightly rotate the hex key until it is engaged in the setscrew.

Using a counterclockwise motion, loosen the setscrew a

quarter-turn at a time.

3.Repeat steps 1 and 2 for the upper setscrew. Gently pull the handle away from the door.

4.If necessary, use a Phillips screwdriver to remove the shoulder screws from the door.

A

A. Shoulder screws

B. Setscrews inside the handle

3.Firmly push the handle toward the door until the handle base is flush against the door.

4.While holding the handle, insert the short end of the hex key into the upper hole and slightly rotate the hex key until it is engaged in the setscrew.

Co_,w_ec_ W,s@e_ Su;s_s v

Read all directions before you begin.

IMPORTANT:

Plumbing shall be installed in accordance with the

International Plumbing Code and any local codes and ordinances.

Use copper tubing or PEX (cross-linked polyethylene) plastic tubing, and check for leaks.

Install tubing only in areas where temperatures will remain above freezing.

TOOLS NEEDED:

Gather the required tools and parts before starting installation.

Flat-blade screwdriver

z/16" and 1/2" open-end wrenches or two adjustable wrenches

1/4" nut driver

Connect to Water Line

IMPORTANT: If you turn the refrigerator on before the water line is connected, turn the ice maker OFF.

1. Unplug refrigerator or disconnect power.

2. Turn OFF main water supply. Turn ON nearest faucet long enough to clear line of water.

3. Use a quarter-turn shutoff valve or the equivalent, served by a 1/2" copper household supply line.

Using a clockwise motion, tighten the setscrew until it begins to contact the shoulder screw.

6.Repeat steps 4 and 5 to begin fastening the lower setscrew.

7.Once both setscrews have been partially tightened as outlined in the previous steps, fully tighten both the upper and lower setscrews.

11

Page 11
Image 11
Kenmore 106.511800 manual Md e sss cHssssRemeved, To Install the Handles, To Remove the Handles