Cut Hazard

Use a sturdy glass when dispensing ice.

Failure to do so can resuR in cuts.

Is the ice dispenser stalling while dispensing "crushed" ice?

Change the ice button from "crushed" to "cubed." If cubed

ice dispenses correctly, depress the button for "crushed" ice and begin dispensing again.

Has the dispenser arm been held in too long? Ice will stop dispensing when the arm is held in too long. Wait 3 minutes for dispenser motor to reset before using again.

The water dispenser will not operate properly

Freezer door closed completely? Close the door firmly. If it

does not close completely, see "The doors will not close

completely."

Refrigerator connected to a water supply and the supply shutoff valve turned on? Connect refrigerator to water supply and turn water shutoff valve fully open.

Is the water pressure at least 30 psi (207 kPa)? The water pressure to the home determines the flow from the dispenser. See "Water Supply Requirements."

Kink in the home water source line? Straighten the water source line.

New installation? Flush and fill the water system.

Water filter installed on the refrigerator? The filter may be clogged or incorrectly installed.

Is a reverse osmosis water filtration system connected to your cold water supply? See "Water Supply Requirements."

Water is leaking from the dispenser

NOTE: One or two drops of water after dispensing is normal.

Glass not being held under the dispenser long enough? Hold the glass under the dispenser for 2 to 3 seconds after releasing the dispenser lever/pad.

New installation? Flush the water system. See "Prepare the Water System" or "Water and Ice Dispensers."

Recently changed water filter? Flush the water system. See "Prepare the Water System" or "Water and Ice Dispensers."

The dispenser water is not cool enough (on some models)

NOTE: Water from the dispenser is chilled to only 50°F (10°C).

New installation? Allow 24 hours after installation for the water supply to cool completely.

Recently dispensed large amount of water? Allow 24 hours for water supply to cool completely.

Water not been recently dispensed? The first glass of water may not be cool. Discard the first glass of water.

Refrigerator connected to a cold water pipe? Make sure the

refrigerator is connected to a cold water pipe. See "Water

Supply Requirements."

ACCESSORIES

Replacement Parts:

To order stainless steel cleaner or replacement filters, call

1-800-4-MY-HOME ® and ask for the appropriate part number listed below or contact your authorized I<enmore dealer.

Stainless Steel Cleaner and Polish:

Order Part #D22 M40083 R

Water Filter:

Order Part #9930 (P4RFWB)

Air Filter:

Order Part #W10335147A

Produce Preserver:

Order Part #W10335145A

WATER FILTER

CERTIFICATIONS

State of California

Department of Public liealtb

Water Treatment Device

Certificate Number

10- 2030

Date Issued: February 26, 2010

Cysts

Organic ('on_t_illants

AtraTme

2.4-D

Rated

Service

Capacity:

200

gat

 

Rated Service Flow:

5 gpm

 

 

 

 

 

 

Conditions

of Certification:

 

 

 

Do

no_

use where

water

is

microbiologically

unsafe

or with ,water of

unknown

quality, except

that systems cerlified

fbr

cyst

reduction

may

be

used on

disinI"i:cted

waters

that Itaay colltain

filterable

cysts,

 

28

Page 28
Image 28
Kenmore 106.511800 manual Accessories, Water Filter Certifications, Water dispenser will not operate properly