Kenmore 10656824603 manual The Dispenser Light, The Dispenser Lock on some models, Indicator

Models: 10656826603 10657076601 10656834601 10656824603 10656833603 10656829601 10657074601 10656836603 10657072601 10656836602 10657034601 10656866601 10656863601 10656832603 10656834603 106.57022601

1 80
Download 80 pages 3.04 Kb
Page 12
Image 12
The Dispenser Light

IMPORTANT: You do not need to apply a lot of pressure to the lever in order to activate the ice dispenser. Pressing hard will not make the ice dispense faster or in greater quantities.

4.Remove the glass to stop dispensing.

NOTE: The first few batches of ice may have an off-flavor from new plumbing and parts. Throw the ice away. Also, take large amounts of ice from the ice bin, not through the dispenser.

The Dispenser Light

The dispenser area has a light. It can be turned on manually by pressing the ON button (touchpad or rocker switch).

On some models: Whenever you use the dispenser, the lever will automatically turn the light on.

LIGHT

OFF ON

NOTE: See "Changing the Light Bulbs" for information on changing the dispenser light bulb.

The Dispenser Lock (on some models)

The dispenser can be turned off for easy cleaning or to avoid unintentional dispensing by small children and pets.

NOTE: The lock feature does not shut off power to the refrigerator, to the ice maker, or to the dispenser light. It simply deactivates the dispenser levers.

To turn off the dispenser, press the LOCK button. The indicator will appear above the LOCK button and the ice and water dispensers will not work. To unlock the dispenser, press the UNLOCK button until the indicator appears. Then continue to dispense ice or water as usual.

DISPENSER

LOCK UNLOCK

The water filter status light will help you know when to change your water filter. When the status light changes from green to yellow, this tells you that it is almost time to change the water filter. It is recommended that you replace the filter when the status light changes to red OR when water flow to your water dispenser or ice maker decreases noticeably. The filter should be replaced at least every 6 months depending on your water quality and usage. To change the filter, see "Changing the Water Filter" later in this section.

INDICATOR:

STATUS:

GOOD (green)

New filter installed

ORDER (yellow)

Order filter

REPLACE (red) OR

Replace water filter

when water flow decreases

 

After changing the water filter, reset the status light by pressing and holding the RESET button for 2 seconds. The status light will change from Replace (red) to Good (green) when the system is reset.

WATER FILTER

G00D•

ORDER• RESEt

RE_LAC_•

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

Changing the Water Filter

The water filter is located in the base grille below the freezer compartment door. It is not necessary to remove the base grille to remove the filter.

1.Remove the filter by pressing the eject button and pulling straight out on the filter cap.

NOTES:

Avoid twisting the cap when removing the filter because this could cause the cap to come off. If this occurs, replace the cap and pull the filter straight out.

There will be water in the filter. Some spilling may occur.

............... B

A. Eject button

B. Filter cap

2.Remove the cap by turning it counterclockwise until it stops.

IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter.

3.Take the new cartridge out of its packaging and remove the protective cover from O-rings.

A.......................

B.................

A.Protective cover

B.O-rings

12

Page 12
Image 12
Kenmore 10656824603 manual The Dispenser Light, The Dispenser Lock on some models, Indicator, A. Eject button B. Filter cap