Kenmore 110.9656 manual Pedestal, Parts supplied, Parts needed, Stack Kit

INSTALLATION INSTRUCTIONS

Gather the required tools and parts before starting installation. Read and follow the safety instructions provided with any tools listed here.

Pedestal

8" or 10" pipe wrench

8" or 10" adjustable wrench (for gas connections)

Flat-blade screwdriver

Adjustable wrench that opens to 1" (2.54 cm) or hex-head socket wrench (for adjusting dryer feet)

v4" nut driver or socket wrench (recommended)

Parts supplied

•Level

•Vent clamps

•Knife

•Pipe-joint compound resistant to LP gas

•Caulking gun and compound (for installing new exhaust vent)

•Pliers

•Tape measure

Are you placing the dryer on a pedestal? You can purchase a pedestal separately for this dryer. This pedestal will add about 10" (25.4 cm) to the height of your unit for a total height of approximately 46" (116.8 cm).

For a garage installation, you will need to place the dryer at least 18" (46 cm) above the floor.

Optional pedestal

Remove parts package from dryer drum. Check that all parts were included.

4 Leveling legs

NOTE: Do not use leveling legs if installing the dryer on a pedestal.

Parts needed

Check local codes and with gas supplier. Check existing gas supply, electrical supply and venting. Read "Electrical Requirements," "Gas Supply Requirements" and "Venting Requirements" before purchasing parts.

•For close-clearance installations between 28.65" (72.77 cm) and 34.15" (86.74 cm), see "Plan Vent System" section for venting requirements.

The pedestal is available in:

White - Part Number 46822

To order, call your local Sears store. For further information, please call 1-800-4-MY-HOME® (1-800-469-4663).

Stack Kit

Are you planning to stack your Kenmore washer and dryer? To do so, find the stack kit in the dryer drum. Follow instructions included with the kit. See "Location Requirements."

I_- 34.15"--_1

(86.74 cm)

Mobile home installations require special parts (listed following) available for purchase from your local Sears store or Sears Service Center. For further information, please call 1-800-4-MY-HOME® (1-800-469-4663).

•Mobile Home Installation Kit. Ask for Part Number 346764.

•Metal exhaust system hardware.

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor

for a garage installation.

Failure to do so can result in death, explosion, or fire.

You will need

•A location that allows for proper exhaust installation. A gas dryer must be exhausted to the outdoors. See "Venting Requirements."

•A grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See "Electrical Requirements."

•A sturdy floor to support the total dryer weight of

127 Ibs (57.6 kg). The combined weight of a companion appliance should also be considered.