IBM A40I TYPE 2271, A40P TYPE 6841, A40 TYPE 6840 manual Diagnostic Error Code

Diagnostic Error Code	FRU/Action
011-000-XXX	1.	No action
Serial port Interface Test Passed
011-001-XXX	1.	Remove external serial device, if
Serial port Presence
		present
	2. Run setup, enable port
	3.	System board
011-002-XXX	1.	System board
011-003-XXX
Serial port Timeout/Parity error
011-013-XXX	1.	System board
011-014-XXX
Serial port Control Signal/Loopback test
failure
011-015-XXX	1.	Wrap plug
Serial port External Loopback failure
	2.	System board
011-027-XXX	1.	Run Setup, enable port
Serial port Configuration/Setup error
	2.	Flash the system
	3.	System board
011-03X-XXX	1.	System board
011-04X-XXX
Serial port failure
011-195-XXX	1.	Information
Serial port Test aborted by user
	2.	Re-start the test, if necessary
011-196-XXX	1.	Press F3 to review the log file
Serial port test halt, error threshold exceeded
	2.	Re-start the test to reset the log file
011-197-XXX	1.	Make sure the component that is called
Serial port test warning
		out is connected and/or enabled
	2. Re-run test
	3. Component that is called out in warning
		statement
	4.	Component under test
011-198-XXX	1.	If a component is called out, make sure
Serial port test aborted
		it is connected and/or enabled
	2. Flash the system and re-test
	3. Go to the ″Undetermined problems″
		section
011-199-XXX	1.	Go to the ″Undetermined problems″
Serial port test failed, cause unknown
		section
	2. Flash the system and re-test
	3. Replace component under function test
011-2XX-XXX	1.	External serial device
Serial port signal failure
	2.	System board
014-000-XXX	1.	No action
Parallel port Interface Test Passed

Chapter 6. Symptom-to-FRU Index 45