Review this table tofind do-it-yourself solutions for minor performance problems. Anyservice needed, other than maintenance described in this Owner's Manual, should beperformed by a Sears or other qualified service agent.WARNING
Disconnect electrical supply before performing maintenance to the unit.Failure to do so could result in electrical shock or personal injury.All Surface Floor
Cleaner won't
run
t.
2.
3.
4.
5.
All Surface Floor 1.
Cleaner won't 2.
pick up or low
suction 3.
4.
5.
6.
Water escaping 1.
from All Surface 2.
Floor Cleaner
3.
All Surface Floor 1.
Cleaner won't
dispense solution 2,
3.
Brushroll not 1.
rotating
2.
3.
Power cord not firmly plugged
intooutlet.
Blown fuse or tripped breaker.
Brush clogged.
Thermal Protector activated.
Needs service.
Incorrectly assembled.
Clean/Dirty Water Tank not
installed properly.
Dirty water tank is full.
Nozzle clogged
Filter clogged or dirty.
Incorrect nozzle attached.
Dirty Water Tank Is full.
Clean/Dirty Water Tank not
installed properly.
Solution trigger pulled.
Clean/Dirty Water Tank not
installed properly.
Clean Water Tank empty.
Solution trigger notpulled
Brush On/Off switch not in
ON position
Brushrolt clogged
Belt broken
1. Plugunit infirmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker.
3. Unplug unit. Remove debris from brushro]l
and push brushron reset button.
4. Unplug All Surface Floor Cleaner. Allow to
cool for 30 minutes before use.
5. Take to Sears Service Center.
1. Reassemble All Surface Floor Cleaner.
2, Secure tank -Pg. 13
3. Empty Dirty Water Tank- Pg. 13
4. Clean nozzle opening.
5. Remove filter and clean - Pg. 14
6. Attach correct nozzle (tangerine for hard
floors, green forcarpets) - Pg. 10-11
1. Empty Dirty Water Tank- Pg. t3
2. Secure Tank- Pg. 13
3. Release solution trigger.
1, Secure Tank.
2, Fill Clean Water Tank.
3. Pull solution trigger.
1. Move Brush On/Off switch to ON position.