Kenmore 116.30912 manual To Remove Dust BAG, To Replace Dust BAG, Do not reuse, Into the body

TO REMOVE DUST BAG

Pull out on the

bag cover release located near the

top of the bag cover,

Pull the bag cover forward

and lift up. Remove and lay aside.

Grasp the dust bag collar and pull gently, carefully removing the dust bag°

Throw away the used dust bag.

Do not reuse.

-BagHolder Check the bag holder and the

rcaviW motor safety fit- ter..If either is blocked, check

TROUBLE-

Safety

FilterSHOOTING.

CAUTION

NEVER REUSE A DUST BAG. Very fine materials, such as carpet fresh- ener, face powder, fine dust, plaster, soot, etc. can clog the bag and cause it to burst before it is full.

Change bag more often when vacu- uming these materials.

TO REPLACE DUST BAG

Unfold the new Dust dust bag. Fold Bag

the safety seal tab on the new

dust bag away from the open- ing that fits on the bag holder,

NOTE: See PARTS AND FEATURES for bag number.

Insert the dust bag onto the bag holder completely by holding the bag collar

Place the dust bag coIlar into position_

Tuck the bag

behind each of the Bag

four bag retention Retention

Corner corner flaps shown Flapst here. Be sure the

bottom and sides of the dust bag are completely within bag cavity prior to replacing the bag

cover,.

l_T!!s	\	Position the bag
Slots		cover so its posi-
		into the body
		positioning	tab
_		slots_	fit
		ioning tabs
Close the bag
cover.
You will hear a
distinctsnap	Bag
when cover is	Cover

securely closed.

Check to see that the dust bag is fully enclosed in the bag cover,

i ,11111 iiiiii i iii