Using a screwdriver,
tighten the screw.
Do not overtighten.
Overtightening could strip the screw holes.
Do not operate the cleaner without
the screw in place,
CORD ASSEMBLY
Make sure the quick release upper cord hook is in the upright position,, Remove the wire tie from the power cord.
HOW TO START
1. Turn the
Re_ase quick release
UpperCord
Hookupper cord hook to either
side and down to release the power cord.
2, Release the power cord plug from the power cord and pull the cord off the quick re_ease upper cord hook. Check to be sure the power cord is still locked into the lock in the quick release upper cord hook_
3.Check to see if the cleaner has bag installed° See DUST BAG CHANGING.
Note: To reduce the risk of electric shock, this vacuum cleaner has a polarized plug, one blade is wider than the
Lock the cord into place by forcing it into the locking notch on the body of the quick
release upper cord hook as shown.
This helps keep the power cord out
from under thePower vacuum cleaner
agitator.
Wrap the power cord around the upper and lower cord hooks and lock the power cord plug onto the power cord_
Quick
Upper Cord
Hook
Power
Lower
Cord
other,, This plug wil! fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plugo If it still does not fit, contact a qualified technician to install the proper outlet. Do not change the plug in any way_
4.Plug the polarized power cord into a 120 Volt outlet located near the floor.
Personal Injury and Product Damage
Hazard
•DO NOT plug in if switch is in the
ON position. Personal injury or dam- age could result.
•DO NOT use outlets above coun-
ters, Damage from cord to items in surrounding area could occur,
iiii | I,H | i ijlllll | ii | I | III |