Kenmore 116.30912 manual Handle Mounted, To select a pile height setting

Release the handle by pressing down on the handle release pedal with your foot and pulling back and down on the handle with your hand.

Note: The agitator will not rotate if the vacu- um cleaner is in the upright position.

Handle

Release

Pedal

HANDLE MOUNTED

SOME MODELS

To start the vacuum cleaner, slide the On/Off switch from the OFF position to the ON position, To stop the vacuum cleaner, slide the On/Oft switch to the OFF position.

Note: This switch operates the suction motor only. For the agitator to rotate, the agitator On/Off selector must be in the ON position and the handle must be released from the upright position.

To select a pile height setting:

Turn off cleaner, r Select a pile height setting by tilting the cleaner back until front wheels are lifted slightly off the floor.

Slide the adjustment lever to the correct set- tingo

There are four (4) pile height settings on the vacuum, Use the LOW setting for most car- pets and bare floor cleaning (with agitator OFF), and the HIGH setting for very long pile carpets like shag carpet, scatter rugs, etc, Use the other settings as needed for carpet heights in-between,

Height

Adjustment

Lever

CAUTION

Do not allow vacuum cleaner to remain in one spot for any length of time when the agitator is turning. Damage to carpet may occur,