Kenmore 141.1764, 141.1664 owner manual BesureyourgrillisOFFandcoolbeforecleaning

Aswithallappliances,propercareandmaintenance willkeepyourgrillintopoperatingconditionand prolongitslife.Byfollowingthesecleaningprocedures onatimelybasis,yourgrillwillstaycleanandwork properlywithminimumeffort.

CAUTION:

BesureyourgrillisOFFandcoolbeforecleaning.

Takecarenottochiporscratchthepaintedsurfaces becauseitwillvoidyourwarrantyagainstrusting.

CleaningThe Cooking Grids

Before initial use and periodically we suggest you wash your cooking grids in a mild soap and warm water solution. You can use a wash cloth or brass brush to clean your cooking grids.

CAUTION:

Take care not to chip or scratch the porcelain finish because it will void your warranty against rusting. Never try to clean your cooking grids unless you are sure the grids are cool to the touch.

Cleaning The Flame Tamers

Periodically you should wash the Flame Tamers in a soap and warm water solution. Use a brass brush to remove stubborn burnt-on cooking residue. Dry the Flame Tamers thoroughly before you reinstall them into the cooking bowl.

Cleaning The Grease Tray and Receptacle

To reduce the chance of fire, the Grease Draining Tray and Grease Receptacle should be visually inspected before each gdll use. Remove any grease and wash grease tray and receptacle with a mild soap and warm water solution.

Annual Cleaning of The Grill Interior

Burning-off the grill after every cookout will keep it ready for instant use. However, once a year you should give the entire grill a thorough cleaning to keep it in top operating condition. Follow these steps:

1.Turn all burner valves to the full OFF position.

2.Turn the LP gas tank valve to the full OFF position.

3.Detach the LP gas regulator assembly from your gas grill.

4.Remove and clean the flame tamers, cooking grids and grill burners.

5.Cover each gas valve orifice with aluminum foil.

6.Brush the inside and bottom of the grill with a stiff brass brush, and wash with a mild soap and warm water solution. Rinse thoroughly and let dry.

7.Remove aluminum foil from orifices and check each orifice for obstruction.

8.Check each spark electrode, adjusting as needed. The space between the Spark Electrode Tip and Spark Receiver should be approximately 3/16".

9.Replace the burners and adjust the gas collector box. The edge of the collector box should be overlapping the burner port.

10.Replace flame tamers and the cooking grids.

11.Reconnect the gas source and observe the burner flame for correct operation.

Cleaning Exterior Surfaces:

Before initial use, and periodically thereafter, we suggest you wash your grill using a mild soap and warm water solution. You can use a wash cloth or sponge for this process. Do not use a stiff wire or brass brush that might remove paint during the cleaning process.

Cleaning Exterior Stainless Steel Surfaces:

Weathering and extreme heat can cause exterior stainless steel surfaces to turn tan in color. Use a

foam or cream Stainless Steel Cleaner to polish the stainless steel surfaces of your grill. Never use abra- sive cleaners or scrubbers because they will scratch

and damage your grill. Follow these steps for the best results.

. Turn the LP gas tank valve (clockwise) to the full OFF position. Disconnect the regulator and hose assembly

from LP gas tank. Cover exposed gas fitting with aluminum foil.

2.Remove dirt or grease using a soft cloth and polish stainless surfaces. Wipe with a soft cloth.

3.Remove aluminum foil from exposed gas fitting and allow grill to air dry before attaching the regulator and hose to your LP gas tank.

18