Kenmore 141.1764, 141.1664 owner manual TOP Panel Cabinet

Assembling 1"he Cabinet Doors

1.Install Door Stops to Bottom Shelf and Top Panel of Cabinet. See Fig. 4. Secure firmly using 4 of the 1/4"xl/2" Phillips head screws and nuts.

2.if you haven't already done so, remove the white protective film from the stainless steel Doors. Attach a Door Handle to each Front Door using 2 of the M4x6mm Phillips head screws provided. See Fig. 8. Be careful not to scratch the door surfaces.

3.When installing the Front Doors, make sure the door bolt holes are located on the hinge sides of the Cart Legs.

4.Install either Front Door by inserting 1/4"x5/8" part4hreaded bolt through the lower door bolt hole of the Front Door and into the tapped hole of the Bottom Shelf. Tighten securely. Next, align the upper door bolt hole of Front Door with the tapped hole in the Top Panel of Cabinet. Insert 1/4"x5/8" part4hreaded bolt provided and tighten securely.

5.Repeat these steps to install the other Front Door.

How To Level The Gritl Cart So The Doors Line-Up

When the top edge of the cabinet doors do not line-up your grill cart needs to be leveled. This step is often required after initial assembly and when your grill has been moved to a new location. To level your grill cart, use an 11/16" open-end wrench to unscrew either front or rear Castor counterclockwise from its Castor Seat (see bottom of the Cart Leg) until the cabinet doors are aligned. See Fig. 5.

Figure 4

TOP PANEL

OF CABINET

HINGE SIDE

OF CART LEGS

DOORSTOPS

Found in

Hardware Pack

BOTTOM

SHELF

Figure 5

UPPER DOOR

BOLT HOLE_

DOOR HANDLE

'\

\

\

TAPPED HOLE

LOWER DOOR

BOLT HOLE

FRONT DOOR

10