Installation Instructions (cont'd)
Installation Checklist
Whether or | not | the element conversion is made, the model |
| ||||||
rating | plate | must | be | marked. | Using | a | hard point ink | pen, |
|
check | the appropriate | block | within | the | model rating | plate, | HOT | ||
which is located adjacent to the lower access panel.
Is the fuse or circuit breaker size correct as shown in the chart in the "Product Specifications" section?
Are the wires from the circuit breaker or fuse service to the water heater's junction box on the correct wire size (gauge) as
shown in the chart m the Product Speclficauons section.
Is the new
installed, and piped to an adequate drain? See "Temperature- Pressure Relief Valve" section.
ls the water heater completely filled with water? See "Filling
the Water Heater" instructions in the "Installation Instructions" section.
Will a water leak damage anything? See "Facts to Consider About the Location sectmn.
COLD
TEMPERATURE-
PRESSURE
RELIEF VALVE
Are the cold and hot water lines connected to the water heater
correctly? See "Water Piping" instructions in the "Installation Instructions" section.
Is there adequate clearance for maintenance around the water heater?
Do you need to call your electric company to check your wiring?
_DISCHARGE PIPE (Do not cap or plug)
De
I6 AIR GAP
FLOOR DRAIN
MODEL RATING PLATE
15
