Installation Instructions (cont'd)
Installation Checklist
• Whether or not the element conversion is made, the model
rating | plate must be marked• Using a hard point ink pen, | HOT | |
check | the appropriate block within the model rating plate, | ||
| |||
which | is located adjacent to the lower access panel. |
|
•Is the fuse or circuit breaker size correct as shown in the chart in the "Product Specifications" section?
• Are the | wires | from the circuit breaker or | fuse | service to | the | CONDUIT_ | |||
water heater's | junction | box on the | correct | wire | size | (gauge) | as |
| |
shown | in the | chart in | the "Product | Specifications" | section? |
|
| ||
• Is the new
installed, and piped to an adequate drain? See "Temperature- Pressure Relief Valve section.
•Is the water heater completely filled with water? See "Filling
the Water Heater" instructions in the "Installation Instructions" section.
•Will a water leak damage anything? See "Facts to Consider About the Location" section.
•Are the cold and hot water lines connected to the water heater
correctly? See "Water Piping" instructions in the "Installation
Instructions sectzon.
•Is there adequate clearance for maintenance around the water heater?
•Do you need to call your electric company to check your wiring?
COLD
TEMPERATURE-
JPRESSURE
RELIEF VALVE
_DISCHARGE PIPE (Do not cap or plug)
tl
I6 AIR GAP
FLOOR DRAIN
MODEL RATING PLATE
15
