Installation Instructions (cont'd)
Water Piping
_WARNING
HOTTER WATER CAN SCAL_. Water heatersare intendedto
i_. uce hot woter..Water heatedto a temperaturewhichwill satisfyclotheswashln&dishwashing,and other sanitizingneeds can scaldand permanentlyinjureyou uponcontact.Some peo- ple are more IE_qyto be permanentlyinjuredbyhot water than others.Theseindudetheelderigchildren,the inlirm,or physicag
ly/mentallyhandicappedIf. anyoneusinghot water inyour home Ett intoone ofthesegroupsor ifthere isa localcodeor statelaw requiringa certaintemperaturewaterat the hot watertap,then youmust take specialprecaution_In additionto usingthe lowest possibletemperature settingthat satisfiesyourhot w_r needs,
ameanssuchas a mixingvalve,should be usedat the hot water tapsusedby these peopleor at the water he_er. Mixingvalves are availableat plumbingsupplyor hanfwerestere_ Followman- ufacturers instructionsfor installationof the valves•Before
changing the factory setting on the thermostat, read the '_TemperatureRegulation"sectionin this manual.
Look at the top cover of the water heater. The cold water inlet is markedcold. Put two or three turns of teflon tape
around the threaded end of _e
ble connectors, connect the cold water pipe to the coldwater inlet of the water heater.
NOTE." This water heater is super insulated to minimize heat loss from the tank. Further reduction in heat loss
can be accomplished by insulating the hot water lines
from the water heater.
|
| INSTALLATION | COMPLETED | USING |
|
|
| SEARS INSTALLATION | KIT |
| |
HOT | OUTLET | FLEXIBLE | WATER | COLD | INLET |
TO | HOUSE | CONNECTORS | WATER | LINE |
This water heater shall not be connected to any heating systems or component(s) used with a
If a water heater is installed in a closed water supply system; such as one having a
shall be provided to control thermal expansion. Contact the
local utility or local Sears Service Center on how to control this situation.
NOTE: To protect against untimely corrosion of hot and cold water fitdngs_ it is strongly recommended that
The iUustration shows the attachment of the water _iping to the water heater. The water heater is equipped with 3A water con- nections.
NOTE: If using copper tubing, solder tubing to an adapter before attaching the adapter m the cold water inlet connec- tion. Do not solder the cold water supply line directly to the cold water inlet• It will harm the dip tube and damage the tanL
Look at the top cover of the water heater. The water outlet is marked hot. Put two or three turns of teflon tape around the
threaded end of the
tors, connect the hot water pipe to the hot water outlet on the water heater.
THREADED TO
SWEAT COUPLING
THREADED TO SWEAT COUPLING
--3/4" THREADED H EAT TRAP
PRESSURE
RELIEF VALVE
--DISCHARGE
PIPE (Do not cap or plus)
%
FLOOR DRAIN
11