Kenmore 153.336512 Troubleshooting Guide contd, Operational Conditions contd, t j tment ion

Models: 153.336151 153.336851 153.336351 153.336251 153.336812 153.336312 153.336751 153.336451 153.336951 153.336512 153.336912 153.336551 153.336412

1 32
Download 32 pages 40.96 Kb
Page 24
Image 24
Troubleshooting Guide (cont'd)

Troubleshooting Guide (cont'd)

Operational Conditions (cont'd)

HIGH TEMPERATURE SHUT OFF SYSTEM

This waterheater is equipped with an automatic gas shut off sys- tem. The high temperature shut off is built into the gas control valve. This system shuts off the gas supply to the water heater burners when high water temperatures are present. It is non- resettable.If the high temperature shut offactivates, the gas con- trol valve must be replaced. If this were to occur,turn _OFF_'the

entire gas supply to the water heater. Contact the Sears Service Center.

AWARNING

Shouldoverheatingoccuror the gassupplyfail to shut off, tom "OFF" the manualgascontrolvalveto the appliance,

NOT ENOUGH OR NO HOT WATER

Check the pilot flame. It mayhave gone out. All models have

ianheckopeningbehindthe manualgastheshutouterdooroffvalve_tor viewingbe suretheit ispilotopen. .

If the pilot is not lit, f_llow the _Lighting"instructions in this manual or located above the gas control valve on the water heater to relight the pilot. If the water was extremdy hot and is now cold, the high limit safety temperature shut off may have put out the burner and pilot. If the high temperature

shut off activates, the gas control valve must be replaced. Contact the SearsServiceCenter.

The

gas control

 

knob

must

be turned

m the

u

ON

n

.

,

 

 

 

 

 

posmon.

 

The

temperature

adjustment

dial may be

set

too

 

low.

See

the

 

 

"Tempetature

Regulation"

section.

 

 

 

 

 

 

 

 

 

The

gas company

can

check

the gas

input

to

 

see if it is

correct.

 

 

An underfired water heater will not heat water as quickly.

 

Look

for leaking

or open

hot

water

faucets.

 

Make

sure

all

are

dosed.

The cold water inlet temperature may be colder during the

winter months. It will take[onget to heat the water and seem like lesshot water.

If you cannot find what is wrong, call the Scars Service Center.

WATER IS TOO HOT

1. The temperatureadjustment dial may be set too high. So: the

t j tment ° ion.

NOTE: A period of time is necessaryafter an adjwtme_t has

been made for the water temperanLee to reach the new tem-

penturesetting.

&WARNING

Due to the nature of the typical gas water heater, the water temperature in certain situations may be hotter

than the thermostat setting.

Short, frequent draws of hot water - especially with very cold incoming water - can shock the thermostat into brief operation resulting in hotter and hotter layers of water closer to the top of the tank.

Changes in hot water usage patterns or raising the tem- perature differential between the cut-on of the thermo- stat and the cold water temperature will usually eliminate the problerr_

2.If lowertemperaturesettingswill not lower the watertempera- ture, call the SearsServiceCenter.

24

Page 24
Image 24
Kenmore 153.336512, 153.336251 Troubleshooting Guide contd, Operational Conditions contd, t j tment ion, penturesetting