INSTALLATION REQUIREMENTS
These instructions are for a horizontal sliding or a casement window. The electricaI outlet must be
within reach of the power cord.
Side louvers and the rear of the air conditioner must have cIear air space to allow enough air flow through the condenser for heat remove.
The rear of the unit must be outdoors, not inside a building or garage.
Horizontal sliding window
i iiiili!ilili!!iii
16 _/" max
II
Casement window
ELECTRICAL SERVICE
Check your available electrical service. The power supply available must be the same as that shown on the unit nameplate (found on right side of cabinet).
AiI models are equipped with a
make the necessary corrections.
SAVE CARTON and this OWNER'S MANUAL for
future reference. The carton is the best way to store unit during winter or when not in use.
To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may be exposed:
•Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are needed to move and install the unit.
To prevent injury or strain, use proper lifting and carrying techniques when moving unit.
•Carefully inspect location where air conditioner will be installed. Be sure it wilt support the
weight of the unit over an extended period of time.
•Handle air conditioner with care. Wear
protective gloves whenever lifting or carrying the
unit. AVOID the sharp metal fins of front and rear coils.
•Make sure air conditioner does not fall during installation.
NOTE!
Before using the air conditioner secure the front grille with two screws enclosed with the owner's manual.
1.Open the inlet grille downward and remove the air filter.
2.Fasten the front grille with screws.
3.Reinstall the air filter.
4.Close the inlet grille.
Inlet Grille