Kenmore 596.762627, 596.762647 Advanced Temperature Control se eotModels, Initial Tempeture Seing

Tempermre

Advanced Temperature Control (se eotModels)

FREEZER	•	8_	_4_ ¸
		00	REFRIG_R:ATOR

@

The control is located at the top front of the fresh food compartment.

Initial Tempe_ture Se_ing

Quick C_bes

Temperatures are preset at the facto_ at 38° F (3 @ C} in the fresh food compartment and 0° F (q7 ° C} in the freezer cornpartmenL

Adjusting the Control

24 hours after adding foo& you may decide that one or both compartments should be colder or warmer. If so, adjust the control as indicated in the Temperature Control Guide below.

-The first touch of the (£-, or :.?:'2pads shows the current temperature setting.

,The display will show the new setting for approximately three seconds, and then return to the actual temperature currently within that compartment

•Do not change either control more than one degree at a time. Allow temperature to stabilize for 24 hours before making a new temperature adiustmenL

Temperature		Control Guide
Refrigerator		too cold Set the Refrigerator control
			to next higher number by
			. pressing	the _;_i) pa&
Refrigerator		too	Set the	Refrigerator	control
warm			to next	lower number		by
			pressing the _v) pad.
Freezer	too	cold	Set the	Freezer control			to
			next higher number		by
			pressing the (_) pad.
Freezer	too	warm	Set the	Freezer control			to
			next lower number		by
			pressing tt_e (v) pad.
Turn refrigerator OFF			Press the Freezer		(_i		pad
			until OFF appears in the
			display°	Press either		the
			Freezer	or Refrigerator			_*Z_)
			pad to turn back on.

When activated, Quick Cubes reduces tt3e freezer temperature to the optimum setting for 24 hours in order to produce more ice,

Important: When the Quick Cubes feature is in operation, the _........, and ("<vi" pads for the freezer control

will not operate.

Reset Filter [select models)

• Q

When a water filter has been installed in the refrigerator, the yellow Order light will illuminate when g0 percent of the volume of water for which the filter is rated has passed through the filter OR 11 months have elapsed since the filter has been instafled.

The red Replace light will illuminate when the rated volume of water has passed through the filter OR 12 months have elapsed since the filter was installed. A new filter should be installed immediately when the Replace light is illuminated.

After replacing the filter, press and hold the Reset Filter pad for three ([3] seconds. The Order and Replace lights will go off.

Vacation Mode [select models)

The Vacation Mode feature causes the freezer to _;,_ defrost less frequently, consen4ng energy: The Vacation Mode indicator light will illuminate when the feature is activated. To deactivate, press the Vacation Mode pad again OR open either door. The indicator light will go out.

Notes:

,Door openings will not deactivate Vacation Mode for approximately one hour aRer activation.

if vacationing for more than a few days, see the Prepanng for Vacation section, page 2&

_3