Kenmore 596.762527, 596.762647, 596.762637, 596.762597 Door and Drawer Removal, Materials Needed

To enhance the appearance and maintain performance,

the refrigerator should be leveled per instructions below.

To protect p_perty and refrigerotor from damage, obsen_e the following:

. Protect vinyl or otl_er flooring with ca_board rugs, or other protective material.

•Do not use power tools when peiforming leve!ing procedure.

Notes:

. Complete any required door reversal, panel installation and/or a water supply connection before leveling.

, Some models only have adjustment screws (A).

Materials Needed:

-_," hex head driver

• Carpentees level

]. Remove toe grille.

. Grasp firmly and pull outward to unclip.

2.Using hex head driver, turn the

front adjustment screws (A) on each side to raise or lower the front of the refrigerator (see illustration beiow)_

,Using the hex head drivec turn each of tl_ese adjustment screws (B) to raise or lower the rear of the refrigerator.

4, Using a carpenter's level, make sure front of refrigerator is ;_" 1_6ram) or approximately }J_bubble higher than hack of refrigerator and that the

level from side to side.

5_ Turn stabilizing legs (C) ctockwt:se untif firmly against floor,

6.Turn adjustment screws (A) counterclockwise until the full weight of the refrigerator rests on the stabilizing legs.

7.Replace the toe grille,

•Align the toe grille mounting clips with the lower cabinet stots.

, Push the toe grille finely until it snaps into place.

Door and Drawer Removal

Some installations require door!drawer removal to transport the refrigerator to its final location,

To avoid electrical shock which can cause

severe personal inju_ or death, observe the followiag:

,Disconnect power to refrigerator befot_ removing doors or drawer. Connect power only after replacing doors or drawer.

To avoid damage to walls and flooring, protect vinyl or other flooring with cardboard, rugs or other protective material.

Materials Needed:

-},4_,"hex head driver

. Phitiips screwdriver

. _" hex head driver

1_ Unplug power co_:d from power source.

2.Remove toe grille.

3.Remove top hinge cover from refrigerator door by removing Phillips screw and retain screw and cover for later use_

4.Unscrew '_1/'hex head screws from top hinge to remove Mnge and retain all screws for later use.

5_ Lift refrigerator door from center Mnge pin, Remove door closure from center hinge pin on tile rigtlt side and f_tain for later use.