CAREOFYOUR SOFTENER
SECTION 3
15
3B.KEEPINGTHEWATERSOFTENERCLEAN
COVERS
To keep your new Kenmore water softener
looking nice, apply a coat of paste wax and
repeat once a year. When dusty, wipe it with a
damp cloth to keep it sparkling.
NOTE:
Never use cleaners having ammonia or abra-
sives. They may scratch and dull the surface.
NOZZLEANDVENTURI
Aclean nozzle and venturi (FIG. 13) is a must for
thesoftener to work right. This small unit moves
brine from the salt storagetank to the resin tank
duringregeneration. If it becomes pluggedwith
sand, silt, dirt, etc., the softener will not work
and you will get hard water.
To get to the nozzle and venturi, remove the
softener top cover. Be sure the softener is in
service cycle (no water pressure at nozzle and
venturi), then turn off the cap from the nozzle
and venturi housing. DO NOT LOSE THE
LARGE O-RING SEAL. Lift out the screen
supportand screen, then the nozzle and venturi.
Wash and rinse the parts in warm water until
clean.If needed,usea smallbrushto removeiron
or dirt. Also check and clean the gasket, small
screen and flow plug.
Carefully replace all parts in the correct order.
Lubricate the o-ring seal with silicone grease or
Vaseline and place in position. Install and
tighten the cap, by hand only.Do not overtigh -
ten and break the cap or housing.
FIG.13
NOTE:Be sureholes inthe
gasketalignwiththe holesat the
bottomof the nozzle&venturi
housing.
*INSTALLWITH
NUMBEREDSIDEUP
CONCAVESIDEDOWN.
Cap
O--ringSeal
ScreenSupport
Screen
Nozzle&Venturi
Gasket
*FlowPlug
(HVDC)
Nozzle&Venturi
Housing
Screen
*FlowPlug
(1--EP)
IRONFROMTHERESINBED
Your water softener takes hardness minerals
(calciumand magnesium) out of the water. Also,
it can control some “clear water”iron0see
maximum allowed in the specifications on page
21. Withclear water iron, water from a faucet is
clear when first put into a glass. After 15 to 30
minutes, the water begins to cloud or turn rust
colored. A water softener WILL NOT remove
any ironwhich makes the water cloudy or rusty
as it comes from the faucet (called red water
iron).To take red water iron out of water, or over
themaximum of clear water iron, an iron filter or
other equipment is needed. Your local Sears
store has trained people to help you with iron
water problems.
If your water supply has clear water iron, even
thoughless than themaximum allowed,regular
resinbed cleaning is needed. Sears has resin bed
cleaner, Stock No. 42-34426 for this. Clean the
bed at least every 6 months. If iron shows up in
thesoft water before6 months, clean more often.
Printed instructions are on theresin bed cleaner
bottle.
IF YOU HAVEQUESTIONS ABOUT CLEANING AND MAINTAINING YOUR SOFTENER,
CALL TOLL FREE, NUMBER 1-800- 426-9345.