OTHERTHINGSTOKNOW
SECTION 4
19
4A.HOWTO“FINE-TUNE”YOUR SOFTENER
c.Press the RECHARGE DAY button ¢and
SUnday begins to flash.
---- If you want regenerations on Sunday (from
regeneration table), press the SET/CLEAR but-
ton £to display ON.
----If youdo notwant Sundayregenerations,press
SET/CLEAR button £to display OFF.
d.Press the RECHARGE DAYbutton ¢again
todisplay a flashing MOnday and ON (facto-
ry set recharge).As you did in step c, use the
SET/CLEARbutton £tochange the display
from ON to OFF,or from OFF to ON.
e.PressRECHARGE DAY button ¢to display
a flashing TUesday, WEdnesday, etc., each
timeusing the SET/CLEAR button £to dis -
play either ON or OFF as needed.
After recharge is either set or cancelled for
SAturday, press the PRESENT TIME AND
DAYbutton ¡once again to return the pres-
ent time and day display.
2.SET THEFILL CYCLEMINUTES
a.Pressand hold the RECHARGE TIME button
©until FILL shows in the display,then re-
lease button ©. After a few seconds, the fill
cycle minutes (factory setting¼8) will flash.
b.Press the SET/CLEAR button £to set the
minutes of fill cycle needed, as shown in the
regeneration table.
NOTE:
Youmay get hard water between regenerations
ifyou set the timer for fewer fill minutes than the
Regeneration Table shows you to set. A higher
setting than needed will waste salt.
NOTE:
Press SET/CLEAR and quickly release to move
thedisplay ahead 1 minute at a time. Or, hold the
SET/CLEARbutton to move the display ahead 2
minutes each second. THE DISPLAY BEGINS
OVER AT0 AFTER PASSING 59.
c.Press PRESENT TIME AND DAYbutton ¡
to return the present time and day display.
TO SET THE PRESENT TIME OF DAY, AND
DAYOF WEEK, SEE PAGE 6.
IF YOU NEED HELP TO PROGRAM THE TIMER, CALL TOLL FREE,
NUMBER 1-800 - 426- 9345.