What Your Hybrid Water Softener Will Do
The Kenmore Elite® Hybrid Water Softener has been designed to include two different types of media, a high quality media that reduces tastes and odors and a high efficiency media to remove hardness minerals. This Hybrid Water Softener will provide you and your home all the benefits of soft water, while providing whole home chlorine taste and odor reduction and bar- ium and radium 226/228 reduction. You can have fil-
tered water from your kitchen faucet for food prepara- tion and drink, in the bath and shower which will reduce chlorine’s aesthetic effect on your skin and hair, and at every bathroom sink for brushing your teeth. There are no filters to change.
Based on
*NSF rated capacity is 570,000 gallons.
Controller Features
EXTRA RECHARGE
Sometimes, a manually initiated recharge (regeneration) may be desired, or needed. Two examples are:
= You have used more water than usual (guests visiting) and you may run out of soft water before the next automatic regeneration.
= You did not add salt to the softener before it ran out. Add salt to the softener before regenerating.
You can start a regeneration immediately, or you can set the controller to regenerate at the next preset recharge time (2:00 AM, or as set).
RECHARGE NOW
Press the REGENERATION button and hold for 3 sec- onds, until the words “RECHARGE”, “Serv” and “Fill” begin to flash in the display. The softener enters the fill cycle of regeneration immediately. This regeneration will take about 2 hours to complete. Then, you will have soft water again.
NOTE: If the “Clean Feature” is set ON, the normal regeneration cycle is preceded by a cleaning backwash and rinse. The words “CLEAN” and “Bkwsh” or “Rinse” flash in the display, along with the minutes of the clean cycle remaining.
Figure 22
RECHARGE TONIGHT
Press and release (do not hold) the REGENERATION button. “RECHARGE TONIGHT” will begin flashing in the display, and the softener will begin regeneration at the next preset recharge time (2:00 AM, or as set). If you decide to cancel the regeneration before it starts, press and release the REGENERATION button once more. “RECHARGE TONIGHT” will stop flashing in the display.
Figure 23
Questions? Call the Kenmore Water Line
16
