OPERATION
Preparing a dishwasher for showroom use
Turn off the power to the dishwasher or disconnect the dishwasher from the electrical power.
WARNING: Danger of electrical shock!
Remove the toe kick and locate the drain pump terminal shown below. Disconnect the terminal from the drain pump by squeezing and pulling it out. Cover the terminal with electrical tape to prevent electrical shock.
Disconnect both ends of the short heater red wire – see section 5.2.3 to remove right side panel for access. Tape the wire with electrical tape to the plastic base so it can be reconnected for resale.
Do NOT connect dishwasher to a water line, but slowly pour about 4.5 liters of distilled water into the tank. The water level should be near the bottom of the fine filter screen in the sump.
Add a small amount of rinse aid and a 1/2 capful of antibacterial agent (bacteriastat) onto the inner door. Do NOT add bleach.
Reconnect the dishwasher and turn it on by pushing the on/off button. Close the door and run dishwasher for one minute. If necessary, add more water until level reaches the fine filter screen.
Preparing a showroom dishwasher for resale
To return the dishwasher back to it’s original condition for resale, enter the special program mode – see section 3.4. Push button “B” repeatedly until the display shows sales demo program mode “P4”. Push button “C” to confirm it.
Push button “B” repeatedly until the display shows the original dishwasher code (e.g. “C1”, “C2”, etc). Push button “C” to confirm it.
Turn power off and then back on. The dishwasher now has it’s original coding. Reconnect the pump and heater that was previously disconnected.
702_58300000149896_ara_en_b
