Using your Dishwasher..continued
=."Refill Rinse Aid" Indicator
Fill the Rinse Aid dispenser when the Refill Rinse Aid message comes on as shown in Figure 23.
23
b)Wait at least ten seconds or until water noises stop before opening the dishwasher door.
c)To resume the cycle, shut the dishwasher door and press the On/Off button.
6. Canceling or Changing a Cycle
a)To cancel or change a cycle, press and hold for three
seconds the two buttons labeled "Cancel Drain" as shown ir Figure 25 until the digital readout shows "0".
25
4. "Sanitized" Indicator
The Sanitized indicator appears on the control panel display as hown in Figure 24.
24
b) Wait for approximately one minute, then press the On/Off button
c) You may now begin a new cycle.
_hen the Sanitized indicator lights, it means that your dishes
have been sanitized according to very strict standards of wash time and water temperature. The standards for sanitization are set by the National Sanitation Foundation (NSF) and are explained in the document ANSI/NSF 184, Residential Dishwashers. More information on NSF standards is available at the NSF website http://www.nsfconsumer.org/home/ appliances.asp.
The dishwasher cycles that are NSF certified are Scrub Wash, Normal Wash, and China Gentle. When these cycles are complete, the "Sanitized" indicator on your dishwasher control panel will illuminate.
Note: If your household water supply is too hot, your dishwasher's heating time may be reduced and the "Sanitized"
light or symbol may not illuminate. Your dishwasher Installation Manual has information on the recommended temperature for your household hot water supply.
E. Wash Cycle Options
1. Top Tier Only TM Cycle
This option allows you to save energy and water by washing loads small enough to fill only the top rack.
Note: The Top Tier Only option does not reduce wash time
To use the Top Tier Only cycle
a)Load the top rack.
b)Press the On/Off button.
c)Press the button for the desired wash cycle.
d)Press the Top Only button.
2.Delay Start
This option allows you to delay the start of the selected wash cycle for up to 24 hours.
a)Press the On/Off Button
b)Press and hold for three seconds the Delay Start button as shown in Figure 26 until the LED display shows the number of hours of delay desired.
26
5. Interrupting a Cycle
NOTE: Should you need to interrupt a cycle (to add or remove an item, to add detergent, etc.), it is best to do so within the first 30 minutes of the cycle.
a)Press the On/Off button to stop the dishwasher.
c) Press the button for the desired wash cycle. You can change the delay time and/or the cycle at any time during the delay.
SCALD HAZARD: You could be seriously scalded if you
open the dishwasher door quickly during a wash or rinse cycle. Do not fully open the dishwasher door for at least 10 seconds after the dishwasher has stopped, or until water noises stop.
10 | Adding Detergent and Rinse Aid | Operating the Dishwasher |
