Kenmore 665.1622 manual osd BotX:o R >ck, Flexible tines on some models, Removable top rack

Standard adjustable 2-position top rack (on some models)

You can raise or lower the top rack to fit tall items in either the top or bottom rack. Raise the top rack to accommodate items up to 9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or lower the top rack to accommodate items up to 11" (28 cm) in both the top and bottom racks. Two adjusters are located on each side of the top rack. Each adjuster has 2 preset positions. The high and low positions are marked on the adjuster.

To adjust the top rack

1.Hold the top rack with one hand near the adjuster.

Flexible tines (on some models)

The row of tines on the left-hand and right-hand sides of the top rack can be adjusted to make room for a variety of dishes.

HIGH

2.With the other hand, pull out the top of the adjuster.

3.Raise or lower the rack to one of the preset positions.

4.Release the adjuster.

5.Repeat the steps for the remaining adjusters.

NOTE: The top rack must be level.

To adjust the flexible tines

1.Grasp the tip of the tine that is in the tine holder.

2.Gently push the tine out of the holder.

3.Lay the tines down, toward the center of the rack.

No-flip clips (on some models)

The no-flip clips hold lightweight plastic items such as cups, lids, or bowls in place during washing.

Removable top rack

The removable top rack allows you to wash larger items

such as stock pots, roasters, and cookie sheets in the bottom rack.

IMPORTANT: Remove dishes prior to removing the rack from the dishwasher.

To move a clip

1.Pull the clip up and off the tine.

2.Reposition the clip on another tine.

To remove the top rack

1.Pull the rack forward slightly to access clips.

2.While pressing the ridges in, push back on the clip until the outer side releases. Slide the clip to the inside of the track edge to remove the clip.

3.After removing both clips, pull rack out.

To replace the top rack

1.Place the rollers on each side of the rack into the rack tracks and push the rack back.

2.Align the open side of the clip with the inside edge of the rack track.

3.Push the ridges and slide the clip toward the outside rack edge until it locks into place.

4.Repeat on the other side.

5.Pull the rack out all of the way to ensure clips are fully seated.

osd BotX:o R >ck

The bottom rack is designed for plates, pans, casseroles, and utensils. Many items, up to 13" (33 cm) tall, fit in the bottom rack. (See recommended loading patterns shown.)

NOTE: The features on your dishwasher rack may vary from the drawings shown.

10 place setting

•Do not load glasses, cups, or lightweight plastic items in the bottom rack. Load small items in the bottom rack only if they are secured in place.

•Load plates, soup bowls, etc., between tines.

•Overlap the edges of plates for large loads.

10