Before Using Your Range
Assembly of Burner Heads & Burner Caps (for Deep Well Cooktop models only)
Your range is shipped with the Burner Heads and Burner Caps the Burner Heads and the cooktop.
a. Be sure to follow the installation instructions before installing and using your new range.
b. Remove all packing tape from cooktop area. Remove all Burner Caps and Burner Heads.
c. Discard all packing material located under Burner Heads. d. To replace Burner Heads & Caps, match the letters
located under center of Burner Caps with the letters located inside Burner Heads (Fig. 1).
in the correct locations. Packing material is located between
e. Match the letters stamped on Burner Skirts with Burner Heads and Burner Caps (See Fig. 1). Replace the Burner Heads and Caps on cooktop (See Fig. 2). Carefully align the Electrodes into slot or hole of each Burner Head (Fig. 3). Note: The Burner Heads should sit flat on Cooktop Burner Skirts.
f. Unpack Burner Grates and position on the cooktop.
Burner Skirt
Fig. 2
_ctrodesmust
Fig. 1 | align into slot or | hole for each |
Fig. 3 | Burner | Head |
Assembly of Burner Heads & Burner Caps (for Ceramic Glass Cooktop models only)
Your range is shipped with the Burner Heads and Burner Caps in the correct locations. Packing material is located between the Burner Heads and burner skirts.
a. Be sure to follow the installation instructions before installing and using your new range.
b. Remove any packing tape from cooktop. Remove all Burner Caps and Burner Heads, except DO NOT RE- MOVE Burner Head for Triple Ring Burner
c. Discard any packing material located under the Burner Heads (except Triple Ring Burner position).
Burner
Head
Burner
Cap
d. Replace right rear Burner Head & Cap onto cooktop. Match the letter for the
e. CAREFULLY (DO NOT FORCE) align the Bridge Burner Head over the 2 Bridge Burner Electrodes located on left side of the cooktop. After placing the Bridge Burner Head on the burner skirt, MAKE SURE that the Bridge Burner Head lies evenly on burner skirt.
f. Replace Bridge Burner Caps. These include 1 Bridge Burner Center Cap (rectangular shaped) and the 2 Bridge Burner End Caps (The Bridge Burner End Caps will fit at either the front or rear Bridge Burner Head locations). Make sure that the tabs located under the Bridge Burner Caps fall into the slots located in the Bridge Burner Head (See black arrows in Fig. 6) and that the Bridge Burner Caps lie flat and evenly on top the Bridge Burner Head.
g. Unpack Burner Grates. Position End Burner Grates on cooktop. Place Center Burner Grate between the end Burner Grates and check that all the Burner Grate legs lie flat on the glass cooktop surface.
Fig. 4
Bridge Burner
Head
I
2 Electrode hole locations
through
Bridge Burner
Head
Fig. 5
must align into slot or hole for Simmer Burner Head
Fig. 7
Fig. 6
