SETTING THE CONTROLS
The refrigerator control functions as the thermostat for the entire appliance (refrigerator and freezer sections). The colder the setting, the longer the compressor will run to keep the temperature colder. The freezer control adjusts the cold air flow from the freezer to the refrigerator.
Setting the freezer control to a lower temperature keeps more cold air in the freezer compartment to make it colder.
AIRFLOW
Cold air circulates from the freezer to the fresh food section and back again through air vents in the wall dividing the two sections. Be sure not to block vents while packing your refrigerator. Doing so will restrict airflow and may cause the refrigerator temperature to become too warm or cause interior moisture buildup. (See air flow diagram below.)
Dispenser
When you press the Water button, the Water icon will illuminate.
When you press the Ice Select
button, either the cube or crushed ice icon will illuminate.
Some dripping may occur
after dispensing. Hold your cup beneath the dispenser for a few
seconds after dispensing to catch all of the drops.
_, CAUTION: The control display is operated by touch. Excessive moisture on the display may cause a malfunction. Please keep the display clean and dry.
_, WARNING: The dispenser will not work if any door is left open or if the control lock is engaged.
Ultra ice
When you touch the Ultra Ice button, the graphic will illuminate in the display and will continue for 24 hours. The function witl automatically shut off after 24 hours.
Temperature | You can stop this | function manually by touching the |
| button one more | time. |
* This function increases both ice making and freezing capabilities.
Water Filter Reset
CHANGE FILTER
The Refrigerator Temp. Control ranges from 33°F to 46°F (O°C to 8°C). Press the Refrigerator Temp. button
to cycle through the available temperature settings one increment at a time.
The Freezer Temp. Control range is from =6°F to 8°F (=21°C to =13°C). Press the Freezer Temp. button to
cycle through the available temperature settings one increment at a time.
NOTE: When changing control settings, wait 24 hours before making additional adjustments. The controls are set correctly when milk or juice is as cold as you would like and when ice cream is firm. If the temperature in either compartment is too cold or too warm, change the setting one increment at a time. Wait 24 hours for the change to stabilize before adjusting again.
When the water filter indicator turns on, you have to change the water filter. After changing the water
filter, press and hold the Ultra Ice (Water Filter Reset) button for three seconds to turn the indicator light off. You need to change the water filter approximately every six months.
©
Blue Ambient Mood Light/Light Sensor E
This light has three settings: On, Off and Auto. If the light is set to the Auto mode, the Blue
Ambient Mood Light will automatically turn on and off: according to the brightness of room, as detected by the light sensor.
17
