Kenmore 795.7103 manual Leveling And Door Alignment

LEVELING AND DOOR ALIGNMENT

Leveling

After installing, plug the refrigerator's power cord into a

3-prong grounded outlet and push the refrigerator into the final position.

Your refrigerator has two front leveling legs--one on the right and one on the left. Adjust the legs to alter the tilt

from front-to-back or side-to-side. If your refrigerator seems unsteady, or you want the doors to close more easily, adjust the refrigerator's tilt using the instructions below:

NOTE: Tools Required: 11/16" (18mm) wrench or fiat blade screwdriver.

1.Remove the base grille (refer to page 10).

2.Turn the leveling leg counterclockwise to raise that side of the refrigerator or clockwise to lower it. It may take several turns of the leveling leg to adjust the tilt of the refrigerator.

NOTE: Having someone push backward against the top of

the refrigerator takes some weight off: of the leveling legs. This makes it easier to adjust the legs.

3.Open both doors again and check to make sure that they close easily. If the doors do not close easily, tilt the refrigerator slightly more to the rear by turning both leveling legs counterclockwise. It may take several more turns, and you should turn both leveling legs the same amount.

4.Replace the base grille.

NOTE: Your refrigerator is uniquely designed with two fresh food doors. Either door can be opened or closed independently of the other. You may have to exert slight pressure on the doors to get them to close completely.

Door Alignment

Both the teft and right refrigerator doors have an adjustable nut, located on the bottom hinge, to raise and lower them to align properly.

If the space between your doors is uneven, follow the instructions below to align the doors evenly:

Use the wrench (included with the Use & Care Guide) to turn the nut in the door hinge to adjust the height. Clockwise to raise or counterclockwise to lower the height.

16