WATER FILTER [_
CHANGE FILTER
It is recommended that you replace the water filter:
*Approximately every 6 months.
*When the water filter indicator turns on.
*When the water dispenser output decreases.
*When the ice cubes are smaller than normal.
]. Remove the old water fllter.
*Lower or remove the top left shelf to allow the water filter to
rotate all the way down.
*Press the push button to open the water filter cover.
NOTE: Replacing the water filter causes a small amount of water
(around 1 oz. or 25 cc) to drain. Place a cup under the front end of the water filter cover to collect any
leaking water. Hold the water filter upright, once it is removed, to prevent any remaining water from spilling out of the water filter.
Pull the water filter downward and pull out. Make sure to rotate the filter down completely before
pulling it out of the manifold hole.
2.Replace with a new water filter.
Take the new water filter out of its packing and remove the protective cover from the
Rotate the water filter up into position and close the cover. The cover will click when closed correctly.
3.After the water filter is replaced, dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air and contaminates from
the system. Do not dispense the entire 2.5 gallon amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60 seconds OFF.
4.Water Filter Bypass Plug
I<eep the water filter
bypass plug. You MUST use the water filter
bypass plug when a replacement water filter cartridge is not available.
CAUTION: DO NOT operate refrigerator without water filter or water filter plug installed.
NOTE: To purchase a replacement water filter, visit a
Sears store or call
order
28
