8. FLUSH OUT THE TUBING
Turn the main water supply on and flush
out the tubing until the water is clear. Shut the water off: at the water valve
after about one quart of water has been
flushed through the tubing.
9. CONNECT THE TUBING TO THE REFRIGERATOR
NOTES:
. Before making the connection to the refrigerator, be sure the
refrigerator power cord is not plugged into the wall outlet.
°If your refrigerator does not have a water filter, we
recommend installing one. If your water supply has sand or
particles that could clog the screen of the refrigerator's water valve. Install the filter in the water line near the refrigerator.
O.TURN THE WATER ON AT THE SHUT OFF VALVE
Tighten any connections that leak.
Reattach the compressor compartment access cover.
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate against the back of
the refrigerator or against the wall.
Push the refrigerator back to the wall.
IMPORTANT: Do not use old, worn or used waterlines, only use new for a better use and service.
Connect only to the supply of drinking water for your safety and health.
Remove the plastic flexible cap from the water valve connection.
Place the compression nut and ferrule (sleeve) onto the end of the tubing.
Insert the end of the tubing into the connection as far as possible. While holding the tubing, tighten the fitting.
12. START THE ICEMAKER
Set the icemaker power switch to the I (ON) position. The icemaker wiii not begin to operate until it reaches
its operating temperature of 15°F
begin operation automatically if the icemaker power switch is in the I (ON) position.
1/4"
Nut
Ferule
(sleeve)
Refrigerator
Connection
Fasten the tubing into the tubing Clamp attached to the back of the refrigeraton
First, loosen the screw fastening the clamp. Next, insert the
tubing in the groove. Finally,
29
