8.FLUSH OUT THE TUBING
Turn the main water supply on and flush out the tubing until the water is clear.
Shut the water off at the water valve after about one quart of water has been flushed through the tubing.
9.CONNECT THE TUBING TO THE REFRIGERATOR
NOTE= Before making the connection to the
refrigerator, be sure that the refrigerator power cord is not plugged into the wall outlet.
1.Remove the plastic flexible cap from the water valve.
2.Place the compression nut and ferrule (sleeve) onto the end of the tubing as shown.
3.Insert the end of the copper tubing into the connection as far as possible. While holding the tubing, tighten the fitting.
Tubing | Ctam_ |
| |
1/4 in. |
| \ | L |
Compression \_,_ |
| ||
Ferrule |
|
| |
Nut |
| _ |
|
(sleeve) |
|
| |
_erator
Connection
10.TURN THE WATER ON AT THE SHUTOFF VALVE Tighten any connections that leak.
_CAUTION: Check to see if leaks occur at the water line connections.
11.PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the wall.
Push the refrigerator back to the wall.
12. START THE ICEMAKER
Set the icemaker power switch to the ON position.
The icemaker will not begin to operate until it reaches its operating temperature of 15°F
35
