BASE GRILLE INSTALLATION
To remove the base grllle:
1)Open the Freezer Drawer. (Drawer not shown for clarity.)
2)Once the drawer is open, and there is sufflcient
clearance, remove the screws on the top of the cover.
To replace the base grllle:
Place the cover into position and then insert and tighten the screws.
PRIOR TO USE
1.Clean your refrigerator thoroughly and wipe off all dust that accumulated during shipping.
2.Instatt accessories such as ice cube bin, drawers, shelves, etc., in their proper places. They are packed together to prevent possible damage during shipment.
3.Allow your refrigerator to run for at least two to three hours before putting food in it. Check the flow of cold air in the freezer compartment to ensure proper cooling. Your refrigerator is now ready for use.
INSTALLATION
The refrigerator should always be plugged into its own individual properly grounded electrical outlet rated for 115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes. This provides the best performance and also prevents
overloading house wiring circuits which could cause a fire hazard from overheated wires. It is recommended that a
separate circuit serving only this appliance be provided.
Shock Hazard:
To reduce the risk of electric shock, do not install the refrigerator in a wet or damp area.
INSTALLATION (continued)
lo To avoid noise and vibration, the unit must be leveled and installed on a solidly constructed floor. If required, adjust the leveling legs to compensate for unevenness of the floor. The front should be slightly higher than the rear to aid in door closing. Leveling legs can be turned easily by tipping the cabinet slightly. Turn the leveling legs left to raise the unit or right to lower it. (See LEVELING AND DOOR ALIGNMENT.)
NOTE: installing on carpeting, soft tile surfaces, a platform or weakly supported structure is not recommended.
oinstall this appliance in an area where the temperature is between 55°F (13°C) and 110°F (43°C). If the temperature around the appliance is too low or high, cooling ability may be adversely affected.
3.Select a place where a water supply can be easily connected for the automatic icemaken
NOTE: The water pressure must be between 20 and 125 psi on models without a water filter and between 40 and 125 psi on models with a water filter.
oToo small of a distance from adjacent items may result in lowered freezing capability and increased electricity consumption charges. Allow at least 24 inches (61 cm) in front of the refrigerator to open the doors.
10
