Kenmore 795.7854, 795.7855, 795.7871, 795.7872 _<

HOW TO REPLACE DOOR HANDLES (795. 78712, 78713, 78722, 78723 Models Olny)

NOTE: Handle appearance may vary from

illustrations on this page.

1. Replacing Refrigerator Handle

•Align keyhole slots (1) on the top and bottom

of the back ofthe handle with the screws (2)

mounted on the front of the door.

•Press the handle against the door front,

making sure that the screws (2)go into the

keyhole slots (1).

•Holding the handle with both hands, press it

firmly against the front of the door and slide

the handle down (3).

_<

Screws

mounted

on door

2. Replacing Freezer Drawer Handle

•Align keyhole slots (4) on the right and left

sides of the back of the handle with the

screws (5) mounted on the front of the

drawe r.

•Press the handle against the drawer front,

making sure that the screws (5)go into the

keyhole slots (4).

•Holding the handle with both hands, press it

firmly against the front of the drawer and slide

the handle to the left (6).

Screws

mounted

on door

®

Keyhole slots

on back of

handle

12

Contents

Main ==trio Page ELlTEJ BOTTOM FREEZER REFRIGERATOR WARRANTY Kenmore Elite Appliance Warranty Master Protection Agreements BASIC SAFETY PRECAUTIONS SAVE THESE INSTRUCTIONS BEFORE YOU THROW AWAY YOUR OLD REFRIGERATOR OR FREEZER IMPORTANT: Please read carefully. TO CONNECT ELECTRICITY RECOMMENDED GROUNDING METHOD USE OF EXTENSION CORDS Page UNPACKING YOUR REFRIGERATOR INSTALLATION NEXT Page Page Page _< Page HOW TO REPLACE DOOR HANDLES (795. 78719, 78729 Models Olny) REMOVING AND REPLACING REFRIGERATOR DOORS CAUTION Page HOW TO REMOVE AND INSTALL THE PULLOUT DRAWER LEVELING AND DOOR ALIGNMENT ENSURING PROPER AIR CIRCULATION MULTI-FLOW SETTING THE CONTROLS ADJUSTING CONTROL SETTINGS FOOD STORAGE GUIDE STORING FROZEN FOOD REFRIGERATOR SECTION WATER DISPENSER REFRIGERATOR SHELVES BO'B'LE HOLDER (795.7855*, 7872* Models Only) HUMIDITY CONTROLLED CRISPER REMOVING HUMIDITY CONTROLLED CRISPER GLIDE'N'SERVE /w// DOOR BIN DAIRY BIN UTILITY/EGG BOX FREEZER SECTION TILTING DOOR ICE BIN TILT-OUT DOOR BASKET FREEZER DRAWER BIN DIVIDER J FILTER GENERAL CLEANING TIPS OUTSIDE INSIDE WALLS (allow freezer to warm up so cloth won't stick) DOOR LINERS AND GASKETS PLASTIC PARTS (covers and panels) CONDENSER COILS LIGHT BULB REPLACEMENT WHEN YOU GO ON VACATION POWER iNTERRUPTiONS WHEN YOU MOVE OPERATION INSTRUCTIONS A newly-installed refrigerator may take 12 to 24 hours to begin making ice. NORMAL SOUNDS YOU MAY HEAR PREPARING FOR VACATION BEFORE YOU BEGIN WHAT YOU WILL NEED INSTALLATION INSTRUCTIONS 1. SHUT OFF THE MAIN WATER SUPPLY 2. CHOOSE THE VALVE LOCATION 3. DRILL THE HOLE FOR THE VALVE INSTALLATION INSTRUCTIONS (CONTINUED) ' ./ 8. FLUSH OUT THE TUBING 6. ROUTE THE TUBING 9. CONNECT THE TUBING TO THE REFRIGERATOR 10. TURN THE WATER ON AT THE SHUTOFF VALVE 11. PLUG IN THE REFRIGERATOR 12. START THE ICEMAKER UNDERSTANDING SOUNDS YOU MAY HEAR REFRIGERATOR DOES NOT OPERATE VIBRATION OR RATTLING NOISE LIGHTS DO NOT WORK COMPRESSOR MOTOR SEEMS TO RUN TOO MUCH DOORS WILL NOT CLOSE COMPLETELY FROST OR ICE CRYSTALS ON FROZEN FOOD ICE HAS OFF-TASTE OR ODOR THERE IS WATER IN THE DEFROST DRAIN PAN THE ICEIMIAKER IS NOT PRODUCING ICE OR ICE CUBES ARE FREEZING TOO SLOWLY CUBES PRODUCED BY ICEIMIAKER ARE TOO SMIALL THE DOORS ARE DIFFICULT TO OPEN TEMPERATURE IS TOO WARM OR THERE IS INTERIOR MOISTURE BUILDUP Page Page .... You r Ho me e www.ma.agomyhome.com 1..800-4..MY..H0ME 0-8oo-46e-4863) 1-800-488-1222 (U.S.A.) 1-800..469-4663 Canada) 1800 827 6655 (U.S.A.) 1 800 361 6665 (Canada)