II
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read this entire manual, including the Important Safety Instructions, before operating this dryer.
CONTROL PANEL FEATURES
0 POWER (On/Off) BUTTON
Pressto turn the dryer ON. Press again to turn the dryer OFF.
NOTE: Pressing the Power button during a cycle will can- cel that cycle and any load settings will 1belost.
0 CYCLE SELECTOR KNOB
The CYCLE SELECTOR KNOB is used to select the
desired dry cycle by rotating the knob in either direc- tion until the desired cycle EED is illuminated. Once
the desired cycle has been selected the standard presets for that cycle will be shown in the display.
These settings can be adjusted using the Cycle . Modifier or
cycle. (See the Cycle Guide on page 20 for allowable settings. Io protect your fabrics, not all settings are
allowed in all cycles.)
0 START/PAUSE BUTTON
Press the START/PAUSE button to begin the cycle. The display will change, and the d.ryer will display the estimated (SENSORDRY) or set time (MANUAL DR.Y) remaining and start tumbling. To pause the cycle at any time, open the dryer door or press PAUSE. To resume the cycle where it was stopped, press START/PAUSE again.
NOTE: If the dryer has beenstopped for more than 4 minutes, the dryer will turn oft automatically.
@CYCLE MODIFIER BUTTONS
Use these buttons to adjust the desired cycle options for the selected cycle. The lights above the buttons show the current selection. See page 23 for a complete description (NOTE: Some settings are not allowed on some cycles.).
0 TIME AND STATUS DISPLAY
The display shows the estimated time remaining and the cycle status. The display also monitors the vent and lint filter status. See page 22 for a complete description.
(_ MY CYCLE
If you have a special combination of settings that you use frequently, you can save these settings as a MY CYCLE.
0 OPTION BUTTONS
The option buttons allow you to select additional cycle options. The controls can be locked or
unlocked by pressing and holding the Control Lock button for 5seconds.
MORE TIME and LESS TIME options are not available with sensor dry cyc es.
For detailed information about the individual options, please see the following pages.
18
II
