II
OPTIONAL ACCESSORIES
(_ ..........................t=J
Usethe LP CONVERSIONKIT for changingthe dryer gas connectionsfrom NaturalGas
Usea pedestalto make | Use the stackingkit to mount | ||
laundryeasier to reach. | the dryer on top of the washer | ||
White = 796.51022 | to savefloor space | ||
Ginger = 796.51028 | D26 | 17002 | (White) |
Chili Pepper= 796.51029 | D26 | 17008 | (Ginger) |
| D26 | 17009 | (ChiliPepper) |
_.
Usethe side vent kitfor
ventingdirectlyon either side or on the bottom. Kit #
(NG) to LiquefiedPropaneGas (LP)
4948EL40020
NOTE: Installationof the LP conversion kit must be performedby a qualified service professional.
STACKING KIT INSTALLATION
This stacking kit includes:
•Two (2) side rails
•One (1) front rail
•Four (4) screws
Tools Needed for Installation: __
•
0Make sure the top surface of the washer is clean and dry. Remove the paper backing from the foam
tape on one of the stacking kit side brackets.
\ | J |
OInstall each side rail on the side of the washer top as shown. Firmly press the foam tape in place at the front. Secure the rear of the bracket with a
screw from the back.
,,, | j |
Dryer
Washer
,,WARNING"
•Incorrect installation can cause serious accidents.
The weight of the dryer and the height of installa- tion make this stacking procedure too risky for one person. Two or more people are required when installing the stacking kit. There is a risk of serious back injury or other injuries.
Do not use the stacking kit with a gas dryer in potentially unstable conditions such as a mobile home. Failure to follow this warning can result in seri- ous injury.
Place the washer on a solid, stable, level floor capable of supporting the weight of both appli ances. Failure to follow this warning can result in seri- ous injury.
Do NOT stack the washer on top of the dryer. Failure to follow this warning can result in serious injury.
If appliances are already installed, disconnect them from all power, water, or gas lines and from drain- ing or venting connections. Failure to do so can result in electrical shock, fire, explosion, or death.
i
OPlace the dryer on top of the washer with the feet slightly forward of the brackets in the side rails as shown. Slide the dryer back until the rear feet are held in place by the rear brackets of the stacking kit. CAUTION: Use care to avoid catching or pinch- ing fingers while positioning the dryer.
OInsert the cross rail between the washer and dryer with the tabs on top. Push the rail back until the tabs are on top of the feet and the screw holes line up. Install one screw on each end of the rail to lock it and the dryer in place.
29
II
