II
SAFETY INSTRUCTIONS FOR INSTALLATION
WARNING: To reduce the risk of fire, electric shock, or injury to persons when using this appliance,
follow basic precautions, including the following:
Properly ground dryer to conform with all governing codes and ordinances. Follow details in the installation instructions. Electrical shock can result
if the dryer is not properly grounded.
Before use, the dryer must be properly installed as described in this manual. Electrical shock can
result if the dryer is not properly grounded.
Install and store the dryer where it will not be exposed to temperatures below freezing or exposed to the weather.
All repairs and servicing must be performed by an authorized servicer unless specifically recommended in this Owner's Guide. Use only authorized factory parts. Failure to follow this
warning can cause serious injury, fire, electrical shock, or death.
To reduce the risk of electric shock, do not install the dryer in humid spaces. Failure to follow this
warning can cause serious injury, fire, electrical shock, or death.
Connect to a properly rated, protected, and sized power circuit to avoid electrical overload. Improper
power circuit can melt, creating electrical shock and/or fire hazard.
Remove all packing items and dispose of all shipping materials properly. Failure to do so can
result in death, explosion, fire, or burns.
Place dryer at least 18 in. above the floor for a
garage installation. Failure to do so can result in death, explosion, fire, or burns.
Keep all packaging from children. Packaging material can be dangerous for children. There is a risk of suffocation.
Do not install nearby heat item. Such as stove,
cooking oven. Failure to do so can cause deform, smoke and fire.
Do not place candle and cigarettes on top of the
product. Failure to do so can cause deform, smoke and fire.
Remove all protective vinyl film from the product. Failure to do so can cause deform, smoke and fire.
Exhaust/Ducting:
Gas dryers MUST be exhausted to the outside.
Failure to follow these instructions can result in fire or death.
The dryer exhaust system must be exhausted to the outside of the dwelling. If the dryer is not exhausted outdoors, some fine lint and large amounts of moisture will be expelled into the laundry area. An accumulation of lint in any area of
the home can create a health and fire hazard.
Use only rigid metal or flexible metal 4 in. diameter ductwork inside the dryer cabinet or for
exhausting to the outside. Use of plastic or other combustible ductwork can cause a fire. Punctured
ductwork can cause a fire if it collapses or becomes otherwise restricted in use or during installation.
Ductwork is not provided with the dryer, and you should obtain the necessary ductwork locally. The end cap should have hinged dampers to prevent backdraft when the dryer is not in use. Failure to follow these instructions can result in fire or death.
The exhaust duct must be 4 in. (10.2 cm) in diameter with no obstructions. The exhaust duct should be kept as short as possible. Make sure to clean any old ducts before installing your new dryer. Failure to follow these instructions can result in
fire or death.
Rigid or semi rigid metal ducting is recommended for use between the dryer and the wall. In special installations when it is impossible to make a connection with the above recommendations, a ULlisted flexible metal transition duct may be used between the dryer and wall connection only. The use of this ducting will affect drying time. Failure to follow these instructions can result in fire or
death.
DO NOT use sheet metal screws or other fasteners which extend into the duct that could
catch lint and reduce the efficiency of the exhaust system. Secure all joints with duct tape. For complete details, follow the Installation Instructions. Failure to follow these instructions can result in fire or death.
II
