TrueHEPAFilterReplacement
1.Turnoff theair cleanerandunplugthe
electrical cord.
2.Remove the front panel by pulling gently from the lower portion of the panel. Do
not force, the panel should remove easily. 3_ Remove the Carbon
plastic frame by gently pulling out from the bottom and down from the top.
4_ Remove the True HEPA Filter and dispose of it.
5.Remove the plastic wrap from the new True HEPA Filter and insert it with the
arrow showing =air flow" pointing in toward the back of the air cleaner. The
white tabs at the top and bottom of the True HEPA Filter will point out to the front of the unit.
6.Reinstall the plastic frame and Carbon
Pre=Filter by inserting tabs up into the air cleaner and gently pushing in at the bottom tab until the frame fits into place snuggly,
7.Replace the front panel by hooking the panel on the top of the unit. Swing the panel in by pushing gently on each side of the unit and then lock it into place.
8.Plug in air cleaner and press POWER button until short "beep" sounds.
9.Press the RESET FILTER button by gently inserting a paperclip into the RESET FILTER hole on the control panel. The light will flash 5 times before a =beep" sounds to indicate the filter has been reset. See figure C on page 8 or
Diag_ 9 to the right.
The air cleaner will take
calibrate the AIR QUALITY sensor. During this time the sensor lights wilt flash on and off. Once the sensor has calibrated, the lights will stop flashing and the unit will begin in AUTO mode.
O
O
@
@
@
@
O
tl
