Filter Replacement
•There are two separate filters:
True HEPA Filter and Carbon
•The CHECK FILTER indicator will signal when to replace the True HEPA Filter_The replacement period will vary depending on the hours of usage, air quality, and location of the unit. However, in most cases of normal use the filter will need to be replaced annually
-Change the True HEPA Filter when the CHECK FILTER indicator is on.
-For best performance, change the Carbon
This filter should be disposed of when changed.
Carbon
1.Turn off the air cleaner and unplug the electrical cord.
2.Remove the front panel by pulling gently from the lower portion of the panel. Do
not force, the panel should remove easily.
3o Remove the Carbon
plastic frame by gently pulling out from the bottom and down from the top°
4. Remove the Carbon
5o Remove a replacement Carbon Pre- Filter from the resealable plastic bag and reseal to maintain the freshness of the remaining filter_
6.Install the Carbon Pre_Fitter onto the plastic frame by pushing against six "hook and loop" squares on the back of
the frame. (Diago 6A)
7o Install the plastic frame by inseding tabs up into the air cleaner and gently pushing in at the bottom tab until the frame fits into place snuggly.
8o Replace the front panel by hooking the panel on the top of the unit. Swing the panel in by pushing gently on each side of the unit and then lock it into place,
9o Plug in air cleaner and press POWER button until short "beep" sounds
IAUTION: Do not wash and reuse the
True HEPA Filter or the Carbon
O
O
\
@
O
10
