Kenmore 85450, 85300, 85150 manual Note For best results and to maximize air, flow

Set-Up Procedure

1 .Remove protective film from the control panel.

2.Remove the front panel by pulling gently from the lower portion of the panel, Do

not force; the panel should remove easily,

3_Remove the plastic frame from the unit. 4, Remove the True HEPA Filter and re-

move the plastic wrapper from the filter,_

5.Install the True HEPA Filter with the arrow showing °air flow" pointing in toward the back of the air cleaner; the

white tabs at the top and bottom of the HEPA filler will poini out to the front of the uniL

6_Open the resealable plastic bag con- taining the Carbon Pre-Filters and remove one filter. Reseal the plastic bag to maintain the freshness of the remaining filter.

7Anstall the Carbon Pre-Filter onto the

plastic frame by pushing against six =hook and loop" squares on the back of the frame. (Diag_ 7A)

8,Install the plastic frame by inserting tabs up into the air cleaner and gently

pushing in at the bottom tab until the frame fits into place snuggly,

9.Replace the front panel by hooking the panel on the top of the unit, Swing the panel in by pushing gently on each side of the unit and then lock it into place.

10.Plug the power cord into a wall outleL

11.Press and hold the POWER button until

a short =beep" sounds_

12oThe air cleaner will take 3-4 minutes to calibrate the AIR QUALITY sensor, During this time the sensor lights will flash on and off. Once the sensor has calibrated, the lights will stop flashing and the unit

will begin in AUTO mode. !3,Remove tab from remote control

(85450185300 only)_

_)

@

@

O

O

Note: For best results and to maximize air

flow:

•Place unit at least 2 feet away from the wall

•Place the unit away from drafty areas, as the sensors may not react accurately,

•Do not place near curtains, furniture, or other items that might inhibit air flow_

•Place the unit on a stable surfacer

O

O

7