REVIEW INSTALLATION
Take a few minutes to complete
this checklist. It will help assure you
that you have a proper installation
and will increase your satisfaction
with your Kenmore laundry center.
[]
[]
Check electrical requirements.
Be sure you have correct electrical
supply and recommended grounding
method.
Check that you have:
• All the tools you started with.
• Removed all packaging materials.
• Removed shipping strap with
three cotter pins.
• Installed all parts listed on
pages 5-10.
[] Check that:
• The laundry center islevel.
• The nutson thefront legs are tight.
[] Check that the water faucets are
turned on.
Ensure that laundry center is
positioned in its final location. Make
sure vent is not crushed orkinked.
FINAL STEPS
[] Plug the power supply cord intothe
grounded outlet or connect direct wire
to power supply.
[] Turn power supply on.
[] Wipe the interior of the dryer drum
thoroughly with a damp cloth to
remove any dust.
[] Remove the blue protective film on
the console and any tape remaining
on laundry center.
[] Take afew minutes and read the
Operating Instructions (pages 38-48)
to fully understand your new laundry
center.
[]
[]
Start the washer and allow itto com-
plete the HEAVY DUTY Cycle.
Start the dryer and allow itto complete
a full heat cycle (not the air cycle).
Alter five minutes, open dryer door.
You should feel heat inside the dryer.
If you do not feel heat, see -[rouble-
shooting information on pages 63-64.
NOTE: You may notice a burning
odor. This smell is common when
the heating element is first used.
The smell will go away.
37