2
3
4
Maintenance
Loosen the lamp unit retaining screw.Loosen the lamp unit screw. (1 piece)
Draw out the lamp unit.Hold the handle and lift the lamp unit upward.
Install a new lamp unit.qHold the lamp unit and push it in.
w Tighten the lamp unit retaining screw. e Turn down the handle of the lamp unit.
r Install the lamp unit cover, and tighten the two retaining screws.
| MENU | 5 Reset the lamp usage time. | |||
|
|
|
|
| |
|
| Perform the following in the standby state. | |||
|
|
| VIDEO PC | OHP |
|
3 | 1 | Press the | , | and | buttons once in that order |
2 |
|
|
| ||
| VIDEO | MENU |
|
| |
| PC | button held down. | |||
|
| with the | |||
| OHP | The LAMP LED then blinks. |
| ||
|
|
|
|
| |
|
| CAUTION |
|
|
|
|
| Do not reset the lamp usage time without replacing the lamp. | |||
|
| The probability of a lamp explosion increases if the cumula- | |||
|
| tive usage time of the lamp is more than 1000 hours. | |||
Lamp Setting
Lamp usage time | 0 H |
Economy mode | O N / OFF |
Quit
NOTE
6 Verify that the display of lamp usage time in the Lamp Setting menu is "0H" as shown to the left.
If the lamp usage time is not reset, reset it by repeating step 5.
CAUTION
Be sure to reset the lamp usage time after replacing the lamp. Otherwise, the correct usage time cannot be known. When the display exceeds 1000 hours, the power to the lamp is forcibly turned off regardless of the lamp's life.
•As a safety precaution, your projector does not turn on unless the lamp unit cover is installed.
•The lamp unit sold separately comes with an air filter as part of the lamp kit. When replacing the lamp unit, be sure to replace the air filter as well. (See page 48.)
47