
Remedy
•The product whose lamp exploded has some small lamp pieces inside. Do not replace the lamp, but return it to the sales office or agent of purchase.
Even though the lamp has exploded, never try to replace the lamp by yourself. The lamp pieces may cause injury.
•Replacing the lamp
•Be sure to turn the lamp off and pull out the power plug when the fan stops, and wait an hour or more before start replacing the lamp.
Replacing the lamp during operation or just after the power is turned off may cause burns due to heat.
Refer to "Lamp Unit Replacement" on page 46 for the procedure.
•Replacing / cleaning the air filter
•Be sure to pull out the power plug when the cooling fan stops before start removing the air filter.
Removing the air filter while the cooling fan is rotating may cause burns injury. Refer to "Cleaning the Air Filter" on page 48 for the procedure.
•Avoiding malfunctions and accidents
•Adjust the adjustable legs (Adjustable feet) to keep the projector horizontal. Using the projector in a tilted status may cause injury when it turns over. Refer to "Adjustable feet" on page 16 or the adjusting procedure.
•Do not disassemble the manganese batteries
•Do not
•Do not do the followings
•Do not put anything heavy on the projector.
•Do not step on the projector, rack, or stand. Do not hold or hang on the projec- tor.
Doing so may cause the projector to turn over or break, resulting in injury. Especially be careful if small kids are near.
•Do not use the rack unless the casters are locked when placing the project on a rack with casters.
Doing so may cause the projector to move or turn over, resulting in injury.
•Do not turn the lamp on/off within one minute after it is turned off/on. Extremely high voltage is generated in the lamp just after it is turned on. Turning the lamp on/off too frequently may cause the lamp to deteriorate or break, resulting in malfunctions of the projector.
•Do not project an image with the lens cap attached.
•Moving the projector
•Be sure to pay attention to the glass surface when moving the projector while holding the handles with both hands.
•If not inserted fully, the material cover may get loose off while you carry it.
•Care of the power cable and plug
•Do not put the power cable near a heater.
Doing so may cause the sheath of the cable to melt down, resulting in fire or electric shock.
•Do not plug or pull out the power plug with wet hands. Doing so may cause electric shock.
•Be sure to pull out the power plug and disconnect any cable connections between units and release the
•If you do not plan to use the projector for a long time, pull out the power plug for safety.
6