Setup of the Graphical Remote Control (GRC) unit
16
7Press the “Code” icon. You can now choose from a list of all the codes available for the device. Select the first code on the list.
8Press the “Check” icon.
9Press the “Enter” icon.
Set up other components in the same way as above.
÷When a code which is not shown in the setup code chart is entered, the entered code disappears automatically.
÷Even when the system control code is connected, some models may not automatically display the “System” screen.
÷With
÷When CD, MD and TAPE are connected through system control cords, select “System”.
Check the operation of the component.
1Display the operation screen of the component to be checked.
2Turn on the component from the GRC and confirm the actual component.
÷If there is more than one setup code, select the “Check” icon. This instructs GRC to send a “Power” test signal to the receiver. If your device turns on, the code you entered was correct. If it does not turn on, try the next code in the list. Continue until one of the codes works.
Although each setup code is designed to work with a Note number of different models, certain codes may not work with some models. (Also, certain codes may only oper-
ate some of the functions available on a given model.) With some models, be sure to keep the Check icon pressed for a while.
÷If the device power cannot be turned ON/OFF, return to 7 and select the net code in the list.
Repeat 7 and 8 until the device power can be turned ON and OFF properly.
Programming remote control functions
Remote control functions of some components may not be available even after the setup codes have been registered. In this case, required functions can be programmed as if the GRC unit “learns” them.
To program STOP as a new control item
1Perform steps 1 to 4 in 1.
2Press the “Modify” icon.
3Select the function to be programmed.
4Aim the device’s remote at GRC and press and hold the button on the device’s remote that corresponds to the command you want GRC to learn.
10 cm÷ This may take a few seconds; do not move GRC or the device’s remote
until GRC displays the the Function change menu again.
÷ Be sure to use the device’s original remote. GRC will not learn commmands from other universal remotes.
Continued to next page