Kenwood CK 300 Electrical Feeder Cable Connection, FEEDER CABLE SECTION TYPE HO5RR-F, L 1 N PE

ELECTRICAL FEEDER CABLE

CONNECTION

To connect the supply cable:

-Remove the screws securing the cover “A” on the rear of the cooker (fig. 11.2).

-Feed the supply cable through the cable clamp “D”. The supply cable must be of a suitable size for the cur- rent requirements of the appliance; see the section “Feeder cable section” (fig. 11.2).

-Connect the wires to the terminal block “B” as shown in the diagram in figure 11.3; or connect the phase wires to the terminal block “B” and the earth wire to the terminal PE as shown in figure 11.2.

-Take up any slack in the cable and secure with the cable clamp “D”.

-Replace the cover “A”.

N.B. The earth conductor must be left about 3 cm longer than the others.

FEEDER CABLE SECTION TYPE HO5RR-F

230 V 3 x 0,75 mm2

PE
N	D
L
B
Fig. 11.2

	230 V
	L1 N PE
		(L2)
PE	Earth
N	Neutral
L	Live		Fig. 11.3

43