Kenwood DPX-MP3120, DPX-U5120, DPX-U6120 Item, Item, Range, Range, Display, Display, Operation, Operation type, X’Over Setting, Car Type Fine Adjustments, Exit Function setting mode

Function of DPX-U6120

DSP Setup

Car Type Fine Adjustments

Adjusting fine tuning of the speaker position compensation value specified at <Car Type Selection> (page 37).

Display	Item	Range
“FRONT”	Front speaker	0 – 440 cm
“REAR”	Rear speaker	0 – 440 cm
“SW”	Subwoofer	0 – 440 cm
		(	: Factory setting)

1Select the source Press the [SRC] button.

Select a source other than “STDBY”.

2Enter Function setting mode Press the [VOL] knob.

3Enter Car Type Adjustment mode

Turn the [VOL] knob and press it when the desired item is displayed.

Select “Audio Control” > “Detailed Setup” > “Car Type Adjust”.

4Select the item you want to set

Operation type	Operation
Selects the item.	Turn the [VOL] knob.
Adjust each item.	Press the [4] or [¢] button.
Set the value	Press the [VOL] knob.

The settings of the delay time are automatically identified and compensated by specifying the distances of each speaker from the center of the vehicle interior.

1 Set the front and rear positions and the height of the reference point to the position of the ears of the person sitting in the front seat, and set the right and left positions to the center of the vehicle interior.

2 Measure the distances from the reference point to the speakers.

3 Calculate the distance difference in accordance with the farthest speaker.

38 DPX-U6120/ DPX-U5120/ DPX-MP3120

Reference point

		+100cm
FRONT		FRONT
		50cm
		80cm
REAR		REAR
	150cm	+70cm

+0cm

SUB-W

5Exit Function setting mode

Press the [   ] button for at least 1 second.

X’Over Setting

Fine adjusting the following setting values corresponding to the X’Over values set in the section <Speaker Setting> (page 37).

Display		Item	Range
“X’Over”
	“Front”	“FC”	Front High Pass Filter
			Through, 30, 40, 50, 60, 70, 80, 90,
			100, 120, 150, 180, 220, 250 (Hz)
		“SLOPE”	Front High Pass Slope
			-6, -12, -18, -24 dB/Oct
	“Rear”	“FC”	Rear High Pass Filter
			Through, 30, 40, 50, 60, 70, 80, 90,
			100, 120, 150, 180, 220, 250 (Hz)
		“SLOPE”	Rear High Pass Slope
			-6, -12, -18, -24 dB/Oct
	“SubWoofer”	“FC”	Subwoofer Low Pass Filter
			30, 40, 50, 60, 70, 80, 90, 100, 120,
			150, 180, 220, 250, Through (Hz)
		“SLOPE”	Subwoofer Slope
			-6, -12, -18, -24 dB/Oct
		“PHASE”	Subwoofer Phase
			Reverse (180°)/ Normal (0°)
			(	: Factory setting)

1Select the source Press the [SRC] button.

Select a source other than “STDBY”.

2Enter Function setting mode Press the [VOL] knob.

3Enter X’Over setting mode

Turn the [VOL] knob and press it when the desired item is displayed.