Various Setups
When a DVD recorded in MPEG Audio is played, this setting makes it possible to select the audio signal output from the digital output connector.
At the factory, the player has been set to "Bitstream" to enable digital connection to an AV amplifier with builtin MPEG decoder. For the nonexistent decoders, set the "Digital Audio" setting to "PCM".
Setting items
"
" : Select to return to the previous screen.
"Bitstream" : The signal is output as a bitstream. Select when connecting a component containing MPEG decoder.
"PCM" : The signal is converted onto 48 kHz (2CH) PCM signal before being output. Select when connecting a component without MPEG decoder.
Operation procedure
1.Set the mode switch of the joystick remote to the Purple position.
2. While the player is in stop mode, press | 1 | and tilt |
SET UP |
the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3.Press ENTER to open the setup screen.
4.In the setup menu, select "Digital Audio MPEG" by tilting the joystick up or down and press ENTER .
Digital Audio | 7 |
|
PCM Down Conversion | 7 | Bitstream |
Dolby Digital | 7 | PCM |
DTS
MPEG
Speaker Setting (Custom)
Speaker Setting (Quick)
Audio During Search
Dynamic Range Control
Audio Filter
5.Select the audio output by tilting the joystick up or down, and press ENTER to enter the selection in memory.
Chapter 6: Various Setups
"Speaker Setting"When an associated system component is connected to the 6CH. OUTPUT jacks of the player, this setting is required on the player.
At the factory, the player has been set to the standard setting with which the speakers can reproduce the 6- channel signals as soon as the connections are made. This setting can be changed according to each listening environment. When you want to change this setting, be sure to perform it in the listening area in your own listening environment.
¶For the "Speaker Setting" when an AV amplifier is connected digitally to the player, refer to the instruction manual of the AV amplifier.
"Speaker Setting (Quick)"
Three kinds of speakers can be set, including the "Center Speaker", "Surround Speakers" and "SubWoofer".
Operation procedure
1.Set the mode switch of the joystick remote to the Purple position.
2. While the player is in stop mode, press | 1 | and tilt |
SET UP |
the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3.Press ENTER to open the setup screen.
4.In the setup menu, select "Speaker Setting (Quick)" by tilting the joystick up or down and press ENTER .
5.Place the cursor on the speaker name you want to set to "Use" or "Do not use", then press the ENTER button.
56