■Power and Speakers cable connection
Distribute the speaker cables and sigma servo cables along the same paths.
Round terminal (Small)
Power control cable (Commercially available part)
Subwoofer
FUSE(20A) | BATT | POWER IN | ∑ SERVO ΙΙ SPEAKER | ∑ SERVO ΙΙ |
20 | GND | |||
|
|
| P.CON(REMOTE) |
|
FUSE(20A) |
|
|
|
|
20 |
|
|
|
|
Terminal cover |
|
| Power control (REMOTE) lead terminal | |
|
|
|
| |
Battery cable |
|
| Round terminal (Medium) | |
|
| Ground cable (Commercially available part) | ||
(Commercially available part) |
|
| ||
Round terminal (Large)
Protective
Fuse Battery
2WARNING
+-
To prevent fire caused by a short in the wiring, connect a fusible link or breaker nearby the battery’s positive terminal.
Wiring
•If a buzzing noise is heard from the speakers when the engine is running, connect a line noise filter (optional) to each of the battery wire.
•Do not allow the cord to directly contact the edge of the iron plate by using Grommets.
•Connect the ground wire to a metal part of the car chassis that acts as an electrical ground passing electricity to the battery‘s negative - terminal. Do not turn the power on if the ground wire is not connected.
•Be sure to attach a protective fuse into the battery wire close to the battery. Use a protective fuse having a capacity that is about 10 A higher than the maximum current drawn by the amplifier.
•Use
•When more than one power amplifier are going to be used, use a power supply wiring wire and protective fuse of greater
Power terminal
Connect to their respective terminals the power control wire, power supply wire, and ground wire, all of which pass through the associated terminal cover. Once the connections are complete, place the cover on the terminal section.
Example: One Power Amplifier Is Used
Maximum Current Drawn | 28 A |
Protective Fuse | 40 A ⋅1 [20 A ⋅2] |
5 mm2 (AWG 10) or | |
Wire (AWG) | greater ⋅1 |
|
|
50 A
25A
25A
25 A 25 A
English 7
