| Installation | ||
| ■ Removing the hard rubber frame | ||
English | |||
1 | Refer to the section “Theft deterrent faceplate (P. 12)” and | ||
|
| then remove the faceplate. | |
| 2 | Engage the catch pins on the removal tool and remove the | |
|
| two locks on the upper level. | |
|
| ||
|
| Push upward the frame and pull it forward as shown in the | |
|
| figure. | |
■Removing the Unit
1 Refer to the section “Removing the hard rubber frame (P. 38)” and then remove the hard rubber frame.
2Remove the
3Insert the two removal tools deeply into the slots on each side, as shown.
Accessory6 | Catch facing up |
Lock
Accessory3
Removal tool
Catch
Accessory3 
Removal tool
3When the upper level is removed, remove the lower two locations.
4Push upward the removal
tool toward the top, and pull out the unit halfway whilst pressing towards the inside.
2CAUTION
Be careful to avoid injury from the catch pins on the removal tool.
5 Pull the unit all the way out with your hands, being careful not to drop it.
NOTE
The frame can be removed from the bottom side in the same manner.
