Kenwood KDC-6015 Function of the KDC-X615, Bass F Adjust the center frequency of the bass

Function of the KDC-X615

"Bass F" : Adjust the center frequency of the bass.

Setting values: 60 / 70 / 80 / 100 (Only when the bass quality factor is set to 1.00, 1.25 or 1.50) / 150 (Only when the bass quality factor is set to 2.00) Hz

NOTE

This mode is available only when the Sound coordinate system is on. (page30)

"Bass"/"BAS" : Adjust the bass level.

Setting values: - 8 – + 8

Function of the KDC-X615

"Bass Q" : Adjust the Bass quality factor. Setting values: 1.00 / 1.25 / 1.50 / 2.00

NOTE

This mode is available only when the Sound coordinate system is on. (page30)

Function of the KDC-X615

"Bass EXT" : Switch the Bass Extend mode on/off. Setting values: ON / OFF

(When the bass extend mode is set to on, low frequency response is extended by 20%.)

NOTE

This mode is available only when the Sound coordinate system is on. (page30)

Function of the KDC-X615

"TreF" : Adjust the center frequency of the treble. Setting values: 10.0 / 12.5 / 15.0 / 17.5 kHz

NOTE

This mode is available only when the Sound coordinate system is on. ( page30).

"Treble"/"TRE" : Adjust the treble level. Setting values: - 8 – + 8

"Balance"/"BAL" : Adjust the balance level. Setting values: Left 15 – Right 15

"Fader"/"FAD" : Adjust the fader level. Setting values: Front 15 – Rear 15

Function of the KDC-X615

"NF Level" : Adjust the Non-fading output level. Setting values: - 15 – + 15

NOTE

•This mode is available only when the non-fading output function is set to on.

•Not available during the Dual zone system is on.

— 9 —