![](/images/backgrounds/218423/218423-5213x1.png)
NOTE
If the faceplate bracket's angle was not set to the vertical when the faceplate was mounted, check that the faceplate is securely attached to the faceplate bracket by holding its right side and pulling it gently towards you.
Audio Control SettingAdjust various parameters of sound quality.
1Press the AUD button to enter the control mode.
2Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will change.
Please refer to the following for the contents of the adjustment modes.
NOTE Source tone memory
Each source (CD, FM, AM, and disc changer) has its own memory in which to store the bass, treble and
3Adjust each mode
Press the 4/¢ button.
Look at the table to adjust the mode being displayed.
4Press the AUD button to end the control mode.
"dB" : Recalling the kenwood preset sound setting Press the preset buttons
Settings: #1;Flat, #2;Rock, #3;Pops, #4;Jazz, #5;Easy, #6;Scan of
NOTE
•This mode is available only when the Sound coordinate system is on. (page 36)
•You can call the following settings with this function; bass centre frequency, bass level, bass quality factor, bass extension, treble centre frequency, and treble level setting. Their setting values are different depending on the setting of the mobile preset plan mode.
“Bass Frq” : Adjust the centre frequency of the bass.
Setting values: 60 / 70 / 80 / 100 (Only when the bass quality factor is set to 1.00, 1.25 or 1.50) / 150 (Only when the bass quality factor is set to 2.00) Hz
NOTE
This mode is available only when the Sound coordinate system is on. (page 36)
“Bass” : Adjust the bass level.
Setting values: - 8 – + 8
“Bass Q” : Adjust the Bass quality factor. Setting values: 1.00 / 1.25 / 1.50 / 2.00
NOTE
This mode is available only when the Sound coordinate system is on. (page 36)
— 13 —