“LPF NFpre” : Adjust the frequency of the Low-pass filter for Non-Fading output.Setting values: 50 Hz / 80 Hz / 120 Hz / Through

NOTE

•This mode is available only when the non-fading output function is set to on. (KDC-8080R only)

•Not available during the Dual zone system is on.

“NFpre Phase” : Adjust the phase for Non-Fading output. Setting values: Normal (0°) / Reverse (180°)

NOTE

•This mode is available only when the non-fading output function is set to on. (KDC-8080R only)

•Not available during the Dual zone system is on.

“VOL OFFSET” : Set the sound level of the each source selected by adjusting the level difference between the basic sound level and the required level.

Setting values: - 8 – 0Storing your sound settings:

Hold down a preset button (#1-6) for two seconds or more except during the bass center frequency, bass level, bass quality factor, bass extension, treble center frequency, and treble level adjust mode.

NOTE

•This setting can be made only when the Sound coordinate system is on. (page 36)

•The settings you can preset are, bass centre frequency, bass level, bass quality factor, bass extension, treble centre frequency, and treble level.

Recalling your sound settings:

Press a preset button (#1-6) except during the bass center frequency, bass level, bass quality factor, bass extension, treble center frequency, and treble level adjust mode.

NOTE

This mode is available only when Sound coordinate system is on. (page 36)Mobile Preset

This function allows you to adjust the setting that is recalled with the sound coordinate system, according to types of speakers.

1Press the SRC button repeatedly to select the standby mode. "ALL OFF" is displayed when the standby mode is selected.

2Press the AUD button to enter the mobile preset plan mode.

3Press either the 4 or ¢ button to select the type of speaker. The setting switches as follows.

Off / For the OEM speaker / For 6/6x9 in. speaker / For 5/4 in. speaker4Press the AUD button to end the mobile preset plan mode.

NOTE

•This setting can be made only when the Sound coordinate system is on. (page 36)

•When you change the setting of type of speaker, the bass and treble tone settings are returned to original levels.

— 15 —